Wilton 41002 manual Maintenance, Replacement Parts

Page 18

Maintenance

Before performing any maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch. Failure to comply may cause serious injury.

Keep the table surfaces clean and free of rust. If rust appears on the tables, use 000 steel wool with a paste mixture of household ammonia and good commercial detergent (or use a commercial rust remover available from most hardware stores.)

A light coat of paste wax on the tables will help protect them from tarnish and reduce friction between table and workpiece. NOTE: Do not get paste wax on the abrasive belt or disc.

Check all fasteners for tightness.

Inspect the power cord; if worn, cut, or damaged in any way, have it replaced immediately.

Inspect the abrasive belt and disc. If either is worn, replace it.

Occasionally remove the belt cover and brush out any shavings or debris from around the wheels.

Lubrication

All of the ball bearings are packed with grease and sealed at the factory. They require no further lubrication.

Replacement Parts

Replacement parts are listed on pages 20-22. To order parts or reach our service department, call 1-800- 274-6848 between 7:30 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately.

18

Image 18
Contents Belt and Disc Sander Part No. M-41002Warranty and Service More Information WMH Tool Group WarrantyTable of Contents Page Page Introduction Specifications Features and Terminology Contents of the Shipping Container UnpackingInstalling Dust Chute AssemblyInstalling Belt Table Tools needed for assemblyInstalling Disc Table Installing Miter GaugeInstalling Tension Handle Grounding Instructions Volt OperationTilting the Belt Table AdjustmentsExtension Cords Tilting the Disc TableUse of the Miter Gauge Belt PlatenAbrasive Belt Replacement Tracking the Abrasive BeltAbrasive Disc Replacement Aluminum Disc RemovalBelt and Disc Movement OperationStarting and Stopping the Sander Typical OperationsPage Maintenance Replacement PartsTroubleshooting TroubleProbable Cause Remedy 2x42x8 Belt and Disc Sander Parts List for 2x42x8 Belt and Disc Sander Index No. Part No Description Size QtyTS-1505021 Socket Head Cap Screw Page WMH Tool Group