Wilton 41002 manual

Page 17

2.Tighten the miter gauge securely so the miter reference angle will not shift while you are sanding.

3.Place the workpiece against the miter reference surface and slide it along the miter reference surface and into the sanding disc.

The following are just some of the many operations that can be performed with your Wilton Sander.

Sharpening a wood chisel on the sanding belt using a block of wood. Use the block of wood to support the chisel and provide clearance for the chisel handle. See Figure 18. Sand a bevel in the block of wood in order to position the block as close as possible to the sanding belt and clamp the block to the table.

A cold chisel can also be sharpened on the belt table with the table tilted.

Sanding aluminum on the disc unit with the table tilted and using the miter gauge as a guide. See Figure 19.

Sanding outside curves on the belt unit with the platen removed. See Figure 20.

Polishing using a felt belt (not provided) in place of the sanding belt. NOTE: Most polishing operations are performed with the platen removed.

Sanding in tight areas with the sanding belt. See Figure 21.

Figure 20

Figure 18

Figure 19

Figure 21

17

Image 17
Contents Part No. M-41002 Belt and Disc SanderMore Information WMH Tool Group Warranty Warranty and ServiceTable of Contents Page Page Introduction Specifications Features and Terminology Unpacking Contents of the Shipping ContainerInstalling Belt Table AssemblyInstalling Dust Chute Tools needed for assemblyInstalling Tension Handle Installing Disc TableInstalling Miter Gauge Volt Operation Grounding InstructionsExtension Cords AdjustmentsTilting the Belt Table Tilting the Disc TableBelt Platen Use of the Miter GaugeTracking the Abrasive Belt Abrasive Belt ReplacementAluminum Disc Removal Abrasive Disc ReplacementStarting and Stopping the Sander OperationBelt and Disc Movement Typical OperationsPage Replacement Parts MaintenanceProbable Cause Remedy TroubleshootingTrouble 2x42x8 Belt and Disc Sander Index No. Part No Description Size Qty Parts List for 2x42x8 Belt and Disc SanderTS-1505021 Socket Head Cap Screw Page WMH Tool Group