Wagner SprayTech 1720, 2120 Before YOU Begin, Plugging in the Sprayer, Pressure Relief Procedure

BEFORE YOU BEGIN

This column contains instructions that will be repeated throughout this manual.

PLUGGING IN THE SPRAYER

1.	Check that the ON/OFF	o
	switch is in the OFF
	position.
2.	Plug the sprayer into a
	heavy duty grounded
	extension cord. Refer to
	Important Electrical
	Information, page 3).

PRESSURE RELIEF PROCEDURE

WARNING

Be sure to follow the pressure relief procedure (page 6) when shutting the unit off FOR ANY PURPOSE. This procedure is used to relieve pressure from the spray hose.

1. Lock the spray gun off.

GX-06/07

GX-08/10

CHOOSING THE CORRECT SPRAY GUN FILTER

Use the proper gun filter based on the tip size being used.

Part No.	Tip Size	Filter	Mesh	Color of	Qty.
		Type	Number	Filter
				Body
0154918	.011	Extrafine	180 mesh	red	2 pack
			0.084 mm
0154675	.013 - .015	Fine	100 mesh	yellow	2 pack
			0.140 mm
0154842	.017 - .023	Medium	50 mesh	white	2 pack
			0.315 mm

BEFORE YOU PRIME THE SPRAYER

Before priming, squirt a teaspoon of separating oil (P/N 0279920 included with unit) into the indicated area. Light household oil can be substituted if necessary. Do not put more than a teaspoon into the lubricating area. Too much oil will leak down into your paint.

IF YOUR UNIT IS NEW. . .

2.Flip the ON/OFF switch to the OFF (O) position.

3.Unlock the spray gun, turn the PRIME/SPRAY knob to PRIME, and trigger spray gun into paint bucket.

4.Lock the spray gun.

o

PRIME SPRAY

All units are performance-tested at the factory and are shipped with test fluid in the fluid section to prevent corrosion during shipment and storage.

•Whether you are going to spray latex or oil-based paints, this fluid must be purged and thoroughly cleaned out of the system (follow Purging and Priming the Pump steps, page 7).

IF YOUR UNIT HAS ALREADY BEEN USED. . .

If the pump has already been used you will need to purge the water or solvent used in cleanup and storage.

PAINT STRAINING

It is recommended that in order to avoid premature tip and gun plugging you should strain your paint before spraying. Follow manufacturer’s recommendations.

English Customer Service: 800-686-8525 6 © 2002 Wagner Spray Tech - All rights reserved.