ASSEMBLY
Installing or removing driver bit or drill bit
CAUTI0N:
Always be sure that the tool is switched off installing or removing the bit.
Turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clock- wise to tighten the chuck.
To remove the bit, turn the sleeve counter- clockwise.
When not using the driver bit, keep it in the bit holders. Bits 45 mm
and the battery cartridge is removed before
-
Bit | Bit holder |
I
Side grip (auxiliary handle)
Always use the side grip to ensure operat- ing safety. Install the side grip so that the teeth on the grip fit in between the protru-
sions on the tool barrel. |
| Teeth |
|
| |
Then tighten the grip by turning clockwise |
|
|
at the desired position. It may be swung |
|
|
360" so as to be secured at any position. | Side grip |
|
| Loosen | Tighten |
12