Makita 8413 instruction manual Installing or removing battery cartridge, Charging

Page 8

FUNCTIONAL DESCRIPTION

Installing or removing battery cartridge

Always switch off the tool before inser- tion or removal of the battery cartridge

To remove the battery cartridge, with- draw it from the tool while pressing the buttons on both sides of the cartridge

*To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place Always insert it all the way until it locks in place with a little click If not, it

may accidentally fall out of the tool, causing injury to you or someone around you

*Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly

Charging

*Your new battery cartridge is not charged You will need to charge it before use Use the high capacity battery charger Model DC1411 (for 8413D and 8433D) / DC1801 (for 8443D) to charge the battery car- tridge

Plug the high capacity battery charger into the proper A C voltage source The charging light will flash in green color

Battery cartridge

Charging light

*Insert the battery cartridge so that the plus and minus terminals on the battery

cartridge are on the same sides as their respective markings on the high capacity battery charger. Insert the cartridge fully into the port so that it rests on the charger port floor.

When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging.

When the charging light color changes from red to green, the charging cycle is complete and the charger will switch into its "trickle charge (maintenance charge)" mode. The charging time is approximately one hour.

*After charging, unplug the charger from the power source

CAUTION:

*The high capacity battery charger Model DC1411 / DC1801 is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer's batteries.

When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times.

8

Image 8
Contents Cordless Percussion=DriverDrill Zlxy General Safety Rules Page Symbols Important Safety Instructions For Charger Battery Cartridge Additional Safety Rules For Charger & Battery Cartridge Installing or removing battery cartridge ChargingSwitch action Trickle charge Maintenance chargeTips for maintaining maximum battery life Reversing switch action Speed changeSelecting the action mode Adjusting the fastening torqueInstalling or removing driver bit or drill bit Side grip auxiliary handleAdjustable depth rod Screwdriving operationDrilling operation Hammer drilling operationInstalling set plate Blow-out bulbMaintenance Replacing carbon brushesAccessories Page Makita Corporation of America