Adjustable depth rod
The adjustable depth rod is used to drill holes of uniform depth Loosen the thumb screw, set to desired position, then tighten the thumb screw
OPERATION
Screwdriving operation
First, turn the action mode changing ring so that the arrow on the tool body points to the c . 4 marking Adjust the adjusting ring to the proper torque level for your work Then proceed as follows
Place the point of the driver bit in the screw head and apply pressure to the tool Start the tool slowly and then increase the speed gradually Release the trigger as soon as the clutch cuts in
*When driving wood screws, predrill pilot holes to make driving easier and to pre- vent splitting of the workpiece. See the chart.
s
Nominal diameter of | ' | Recommended size of | |
woodscrewl"l |
|
| pllot hole 1") |
3 1 11/8"1 |
| 2 0 - 2 2 15/64'' - 3/32") | |
3 5 19/64',) |
| 2 3 - 2 5 13/32" ~ 3/32',) | |
3 8 15/32") |
| 2 5 - 2 8 13/32''- 7/64',) | |
4 5 (1 1/64"J |
| 2 9 - 3 2 (7164" - 1/8"J | |
4 8 (3/16") |
| 3 1 | - 3 4 (1/8" - 9/64") |
5 1 113/64") |
| 3 3 - 3 6 1,IlE'' - 9/61") | |
5 5 17/32") |
| 3 7 | - 3 9 (914'' ~ 5/32") |
5 8 17/32") |
| 4 0 | - 4 2 15/32'' - 11/64") |
6 1 I15/64 "1 |
| 4 2 | - 4 4 11 1/64" - 11/64") |
*If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery.
13