Trickle charge Maintenance charge, Switch action

If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charging light may flash in red color If this occurs, wait for a while Charging will begin after the battery cartridge cools The battery cartridge will cool faster if you remove the battery cartridge from the high capacity battery charger

If the charging light flashes alternately in green and red color, a problem exists and charg- ing is not possible The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge IS worn out or damaged

Trickle charge (Maintenance charge)

If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its "trickle charge (maintenance charge)" mode and keep the battery cartridge fresh and fully charged.

Tips for maintaining maximum battery life

1.Charge the battery cartridge before completely discharged.

Always stop tool operation and charge the battery cartridge when you notice less tool power.

2.Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.

3. Charge the battery cartridge with room temperature at 10°C - 40°C (50°F - 104°F). Let a hot battery cartridge cool down before charging it.

Switch action

CAUTION

Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released

To start the tool, simply pull the trigger Tool speed is increased by increasing pres- sure on the trigger Release the trigger to stop