Plantronics W745A-M manual Set the range, End subscription, Disabling over-the-air subscription

End subscription

If the base is in subscription mode and you want to stop the base from searching for a headset, press the subscription button again. The subscription light will be solid red for four seconds and then go to its previous state.

Disabling over-the-air subscription

The Savi system is supplied with the over-the-air subscription enabled. In a multi-shift environment, you may want to disable this mode of subscription. You can enable/disable over- the-air subscription with the base subscription button or with the Plantronics Control Panel.

While your system is idle, hold the subscription button and the PC phone button down simultaneously until the PC phone button LED flashes. It will flash red for 4 seconds when over- the-air subscription has been disabled or green for 4 seconds when enabled.

You can also enable/disable over-the-air subscription with the Plantronics Control Panel. Go to

Start > Programs > Plantronics > Plantronics Control Panel > Device Settings > Base > Over-the-

Air-Subscription.

Base subscription button LED

	Base subscription LED	Base status
	Flashes green and red	Primary headset subscription mode
	Solid green	Primary headset subscribed to base
	Solid yellow	Active conference call with guest headsets
	Solid red	No headset subscribed
Set the range
	Changing the range can help with desk phone/PC audio quality, improve user density or
	restrict the range of users.
	You can change the range using the subscription button on the base. With the system idle,
	press the subscription and desk phone buttons for three seconds. The desk phone button will
	flash green for high range. If you press the subscription button again for three seconds, the
	desk phone button will flash yellow for medium range. If you press the subscription button
	again for three seconds, the desk phone button will flash red for low range.
	Setting	Range
	High	up to 350 ft.
	Medium	up to 150 ft.
	Low	up to 50 ft.
	You can also set the range using the Plantronics Control Panel. Go to Start > Programs >
	Plantronics > Plantronics Control Panel > Device Settings > Base > Range.
Bluetooth pairing button	Auto connect feature
	Once you have paired and connected your mobile phone to the base, the base will automatically
	connect to it when you are in range of your base.

You can manually disconnect your mobile phone from the base by short pressing the base

Bluetooth pairing button when it is solid blue. However if you do this, you must manually re-

23