Friedrich CP06/CP08 manual Troubleshooting Tips, Normal Operation

Page 18

Troubleshooting Tips

Troubleshooting Tips save time and money! Review the chart below first and you may not need to call for service.

Normal Operation

You may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy days or when the humidity is high. This design feature helps remove moisture and improve efficiency.

You may hear the thermostat click when the compressor cycles on and off.

Water will collect in the base pan during high humidity or on rainy days. The water may overflow and drip from the outdoor side of the unit.

The fan may run even when the compressor does not.

Your air conditioner is designed to cool in warm weather when the outside temperature is above 60°F(16°C) and below 115°F(46°C).

Abnormal Operation

Problem

Possible Causes

What To Do

 

 

 

 

 

 

The air conditioner is

• Make sure the air conditioner plug is pushed

 

 

unplugged.

completely into the outlet.

 

Air conditioner

The fuse is blown/circuit

• Check the house fuse/circuit breaker box and

 

breaker is tripped.

replace the fuse or reset the breaker.

 

does not start

 

 

Power failure.

• If power failure occurs, turn the mode control to Off.

 

When power is restored, wait 3 minutes to restart the air conditioner to prevent tripping of the compressor overload.

The current interrupter device was tripped on the power cord.

Press the RESET button located on the power cord plug. If the RESET button will not stay eng aged, discontinue use of the air conditioner and contact a qualified service technician.

Airflow is restricted.

• Make sure there are no curtains, blinds, or furniture

 

blocking the front of the air conditioner.

The THERMOSTAT may

• Push temperature setting button to coolest

not be set high enough.

temperature setting of 60°F.

Air conditioner does not cool as it should

The air filter is dirty.

The room may have been hot.

Cold air is escaping.

Clean the filter at least every 2 weeks. See the operating instructions section.

When the air conditioner is first turned on you need to allow time for the room to cool down.

Check for open furnace floor registers and cold air returns.

Set the air conditioner's vent to the closed position.

Cooling coils have iced up. • See Air Conditioner Freezing Up below.

Air conditioner Ice blocks the air flow and

freezing up stops the air conditioner from cooling the room.

Set the mode control on high fan until the ice thaws out. This may indicate a bigger problem.

17

Image 18
Contents CP06 CP08 Table of Contents Introduction Before Operating Your UnitFor the Best Cooling Performance and Energy Efficiency Safety Precautions EnglishPage This button can automatically control the air flow direction Adjusting the Air Flow Direction Adjusting the Air Flow DirectionVent Control Care and Maintenance Air FilterDrainage Product Features Hardware LocationInstallation Instructions How to Install the Unit Window RequirementsInstallation Kit Contents English Cabinet Installation Open the window. Mark a line on centerPower cord ScrewType a With a Type C Through-the-Wall Installation Instructions-Optional Troubleshooting Tips Normal OperationRoom AIR Conditioners Limited Warranty De votre climatiseur de pièce Table des matières Avant dutiliser votre appareil Nutilisez Jamais un fil de rallongeMesures de Sécurité AvertissementBords POINTUS! Les bords du cas peuvent être pointus Fonctionnement de la télécommande CP Oscillation AutomatiqueCommande de l’orifice de ventilation Réglage de lorientation du débit dairRéglage de l’orientation du débit d’air Soins et entretien Filtre à airInstallation du matériel Caractéristiques particulières de l’appareilPage Installation de l’appareil Dimensions de fenêtre minimalesContenu du nécessaire d’installation Outils recommandés Préparation DU CadreInstallation du boîtier Angle avantCordon Dalimentation Vis Type a 1 Vis Type a Étrier de verrouillage de fenêtre Installation sur le mur Instruction facultative Page Garantie limitée Climatiseurs Friedrich CP Lines Contenidos Introducción Provee buen flujo de airePrecauciones de segoridad Advertencia PrecaucionPrecaucion Funcionamiento del control remoto CP Ajustar la dirección del flujo de aire Control de ventilaciónAjustar la dirección del flujo de aire Cuidado y mantenimiento Filtro de Aire aDrenaje Instalación de la unidad Funciones del productoPage Cómo instalar la unidad Requisitos de la ventanaContenidos de los conjuntos de instalación Requisitos sugeridos de las ventanas Preparación DEL ChasisInstalación del gabinete Asiento de la ventana Angulo frontalTornillo Tipo a Abrazadera de fijación Page Instrucciones de instalacion a traves de la pared opcional Page Garantia Limitada -PRIMER AÑO Friedrich AIR Conditioning CO

CP06/CP08 specifications

The Friedrich CP06 and CP08 models are pioneering climate control solutions designed to enhance indoor air quality and comfort. Combining state-of-the-art technology with user-friendly designs, these portable air conditioning units are ideal for both residential and commercial settings.

One of the standout features of the Friedrich CP units is their impressive cooling capacity. The CP06 model offers a cooling output of approximately 6,000 BTUs, effectively cooling spaces up to 250 square feet, while the CP08 steps it up to 8,000 BTUs, catering to rooms of up to 350 square feet. This versatility makes them suitable for various applications, from small bedrooms to larger living areas.

Energy efficiency is another hallmark of the Friedrich CP series. Both models are designed with a high Energy Efficiency Ratio (EER), minimizing electricity consumption while maximizing performance. This energy-saving capability is crucial for environmentally-conscious users looking to reduce their carbon footprint and lower energy bills.

Furthermore, the Friedrich CP06 and CP08 come equipped with advanced technologies that enhance user experience and comfort. For instance, the models feature a programmable timer and a remote control, allowing users to adjust settings from a distance. This convenience ensures that spaces are cooled to the desired temperature before arrival, combining comfort with efficiency.

In terms of design, the units boast a sleek and modern appearance that complements various interior styles. They are designed to be portable, with integrated handles and caster wheels, making it easy to move them from one room to another. Additionally, both models operate quietly, ensuring minimal disruption in home or office environments.

The Friedrich CP series emphasizes air quality, incorporating a washable, reusable filter that captures dust, pollen, and other airborne particles. This feature not only maintains cleaner air but also prolongs the lifespan of the unit.

In summary, the Friedrich CP06 and CP08 portable air conditioners deliver exceptional cooling performance, energy efficiency, and user-friendly features. With their advanced technology, silent operation, and emphasis on air quality, these models stand out as reliable solutions for maintaining comfort in any indoor setting. Whether for a home or business, the Friedrich CP series is an investment in both comfort and sustainability.