Figure8
2.Pullthebatterypackstraightout
fromthehandle.
Toturnthetoolon:
1.Gripthecontrolgripfirmlywithone handandgriptheauxiliaryhandleon thetoolattachment(ifprovided)with theotherhand.
2.Pushthetriggerthatyourthumb
restsonstraightforward,thisisthe safetyrelease(seefigure9).
Figure10
To turn the tool off:
1.Release the control trigger and the tool wilt turn off. The thumb switch will return to the rear position to prevent accidental
The power handle can be operated in two positions, normal and inverted, depending on the work you are trying to do. Depending on work position, both thumb switch or control trigger wilt release safety or activate tool, so it is not necessary to contort your hand when using the power handle in the inverted position. (see figure 11)
Figure 9
3.While holding the switch under your thumb in the forward position, use your fingers to pull upward on the control trigger. (see figure 10) This will energize the tool and allow you to do your work. It is NOT necessary to keep pressure on the thumb switch after the tool has started.
Please note that the tool will not start if the lock ring is not in the fully locked position.
Figure 11
OVERLOAD PROTECTION
Some tool attachments incorporate
overload protection devices such as fuses and circuit breakers. These
devices will cause the tool to stop operating if an overload condition exists. See the individual tool