ACTiSYS CAM-6500 user manual Reset Button, Communication Switch Setting

Page 12

1.4Physical Description

Indoor High Speed Dome Bottom

1.Reset Button

Step 1: Switch off IP device by disconnecting the power cable

Step 2: Press and continue to hold the Reset Button. Reconnect the power cable while continuing to hold the reset button.

Step 3: Keep holding the reset button depressed around 6 seconds, release the reset button. The unit will start up with factory default settings.

2.Communication Switch Setting

The table below shows the function of each pin within the

Communication Switch.

Communication Switch		Pin 1	RS-232 Setting (Reserved)
		Pin 2	RS-232 Setting (Reserved)
		Pin 2
		Pin 3	Termination

7

Image 12

Contents Hardware User’s Manual Copyright TrademarksLiability FCC/CE Regulation Table of Contents Page Introduction Day/Night Features Precise and Accurate TrackingPerfect Contrast Solution for High Image Quality QoS Enabled Video StreamingLow-Light Application Privacy Mask for Privacy ProtectionBundle Powerful Surveillance Software Dynamic Dome ConfigurationDdns Supported Build-in Hardware Motion DetectionDon’t use the power supply with other voltages Don’t open the housing of the product CleaningDamage Requiring service AttachmentsSafety Check Reset Button Communication Switch SettingDome ID Setting Dome Control ProtocolPin Connector for LAN/WAN Pin ConnectorMounting the IP High Speed Dome Basic Connections Optional Accessories Surface Ceiling MountIn-Ceiling Mount Ceiling Panel Transparent Cover/Smoke CoverIndoor Mount Kit Gooseneck Tube Straight TubeCorner Standard Mounting Plate Pole Thin Direct Mounting Pole Wide Direct MountingCorner Thin Box Corner Wide BoxPole Thin Box Pole Wide BoxWall Box Mounting Stainless Steel Straps Stainless Strap CutterRepeater/Converter Connector Box Indoor Application Power BoxPower Adapter Ceiling Mount Surface Ceiling Mounting Items NeededTools Needed Drill these holes on the surface ceiling Ceiling Panel for In-ceiling Mounting In-ceiling Mounting StepPut up the T-Bar into the ceiling hole Step Ceiling Mount with Straight Tube Wall Mount Wall Mounting with Gooseneck TbleWall Box Mounting Corner Mount Corner Standard Mounting PlateCorner Thin/Wide Box Mounting Pole Mount Pole Thin/Wide Direct MountingPole Thin/Wide Box Mounting OSD Setup Menu OSD Display Format¾ 18x Model Camera Backlight Home Cruise ¾ 22x Model / 23x Model ScheduleManual Aperture Enter Exit YES Sequence Line WDR Configuration Menu Default Camera BacklightFocus ¾ 18x Model AutoManual ¾ 22x Model / 23x Model AutoAE Mode ApertureAuto Bright ShutterGain IrisWBC Mode AGCIndoor Outdoor ATWID Display Setup Menu OFF18x Model 22x Model / 23x ModelImage Zoom SpeedSpeed by Zoom Auto Calibration Digital ZoomSlow Shutter Angle Adjuster ResetSetup MENU2 18x Model Only ¾ 23x ModelMask Display FirstLast Title DisplayTitle Setting Title ABCAlarm Setting Alarm PINAlarm Switch Alarm TypeAlarm Action PresetHome Setting SequenceSelect Mode Home FunctionReturn Time Preset Position SeqenceSequence Line Sequence PointDwell Time RUN Sequence Autopan Line Start PointEND Point DirectionRUN Autopan Record Start Record ENDRUN Cruise IR Function Removable IR CutAlarm Detect 18x Model Only Detect SwitchThreshold IR ColourDetect Mode INT. FocusFIX Focus INT. AEWDR Switch WDR FunctionPrivacy Privacy Switch TransparencyColour SET MaskSize 00 ~ ShadeMask CLEAR+RESET CENTER000 ~SIZE000 ~ Time Function Time DisplayYear / Month / DAY Hour / MinuteSchedule Switch Schedule ModeSchedule Point Schedule Hour / Minute