Troubleshooting Reference
Table 2 Troubleshooting Reference
Problem | Possible Cause | Solution |
|
|
|
No output voltage. The Status LED is green | GFCI has tripped or 15A supplementary | Check load and reset the GFCI or supplementary breaker. |
or yellow. | breaker has tripped. |
|
| Circuit breaker on the AC load panel or | Reset the circuit breaker or check the AC output disconnect |
| AC output disconnect has tripped. | circuits. |
| Battery voltage is too low (depending | Check DC connections and cable. |
| on setting, see “Operating Limits” on | Recharge battery. |
| page 21) to start inverting. Display |
|
| screen may show DC voltage as .. |
|
|
|
|
No output voltage. The status LED is not | AC shore power is not available or out | • Check AC shore power. |
lighting up. | of operating range and the inverter is | • Turn the inverter ON. |
| OFF. |
|
|
|
|
| AC shore power is not available and the | • Check AC shore power and battery voltage. |
| inverter is OFF due to a shutdown for | • Turn the inverter ON and look at the display panel for any |
| more than 30 seconds. | error code. |
|
| • See Table 1, “Error Codes Displayed on the Display Panel |
|
| Screen” on page 33. |
|
|
|
| The inverter’s DC input polarity is | The inverter was probably damaged due to the reverse polarity. |
| reversed. | This type of damage is NOT covered by the warranty. |
|
| • Return the unit. |
|
| • See Warranty Card for information on returning the unit. |
|
|
|
38 | Freedom HF Owner’s Guide |