Toshiba VF-AS1 instruction manual Automatic edit function, Press Key to select

■ How to search and reprogram parameters

The operations of search and resetting of parameters are as follows.

Key operated LED display

E6581301

5.21Searching for all reset parameters and changing their settings

"￿￿

: Automatic edit function

•Function

Automatically searches for only those parameters that are programmed with values different from the standard default setting and displays them in the user parameter group "￿￿. Parameter setting can also be changed within this group.

Note 1: If you reset a parameter to its factory default, the parameter will no longer appear in "￿￿.

Note 2: It may take several seconds to display changed parameters because all data stored in the user parameter group "￿￿ is checked against the factory default settings. To cancel the parameter group search in process, press the MODE key.

Note 3: Parameters which cannot be reset to the default setting after setting ￿￿￿ to ￿ are not displayed.

￿Refer to Section 5.20 for details.

5

					Operation
			Displays the operation frequency (operation stopped).
		￿￿￿￿	(When standard monitor display selection ￿￿￿￿=￿ [Output
			frequency])
MODE		￿￿￿￿	The first basic parameter “History function (￿￿￿)” is displayed.
		"￿￿￿	Press	or	key to select "￿￿.
ENT		￿￿￿￿￿	Press the ENTER key to enable the user parameter automatic edit
			function.
ENT			Searches for parameters that are different in value from the standard
or		￿￿￿￿	default setting and displays those parameters. Press the ENTER key
			or the	key to change the parameter displayed. ( Press the
			key to search for parameters in reverse direction.)
ENT		￿￿￿￿	Press the ENTER key to display the set value.
		￿￿￿￿	Press the		key and key to change set value.
ENT		￿￿￿⇔￿￿￿￿	Press the ENTER key to save the changed value. The parameter
			name and the programmed value will flash on and off alternately.
		￿￿￿￿￿	Use the same steps as those given above to display parameters that
(	)		you want to search for or change setting with the			key and
		(￿￿￿￿)
			key.
(	)	"￿￿￿	When ""￿￿" appears again, the search is ended.
			A search can be canceled by pressing the MODE key. Press the key
MODE		Parameter display	once while the search is underway to return to the display of
		↓
		￿￿￿￿￿	parameter setting mode.
MODE		↓	After that you can press the MODE key to return to the status
		￿￿￿￿	monitor mode or the standard monitor mode (display of operation
			frequency).

E-44