Folding the Unit for Storage/Transportation

!Make sure X-Bench is not plugged in and WARNING main outlet is off.

8.Power Switch

a. The female plug is located on the bottom of the switch and the male plug is located on the side of the switch box (Fig. 11). Connect the switch box to an electrical outlet by using an extension cord. Plug the desired tool into the female plug and turn the switch box for power on by raising the tab. Power is now activated to the tool that is plugged into the switch box.

b. To deactivate the power, the user can push the bump off switch located on the front of the switch box. When leaving the workstation it is recommended that the user removes the lock off key, to prevent unauthorized usage. (15 A maximum use for switch box.)

Fig. 11

Extension

Cords

Extension

Cords

9. Folding the Unit for Storage/Transportation

a. Position the table on its side or inverted and compress all four legs to the zero position (Fig. 12)

Fig. 12

b. To place the legs inside of the table, the user must press the lock-pin located in the middle of the leg brace and pull on the brace (Fig. 13).

		Fig. 13			Push pin and pull on brace to
					release.

The brace and leg can now be folded into the table. Follow this step for each of the legs.

! WARNING	Keep hands clear of the pivot areas when folding
	the legs inward as this can cause pinching.

c. Once all the legs are inside the table, unlock the table by turning the main knob to keep unlocked. See Section 1a for more details. While the table is unlocked, this will allow the user to fold the table in half.

!WARNING Keep hands and other body parts from folding area. Pinch points may occur during this

step.

d. Once the table is folded in half, the knob must be turned back to the locked position. See Section 1b for more details. If this step is not done, the table can open while the user is carrying the product.

Accessory Installation

(Each Insert and Tool Sold separately)

10. Downdraft Table (Sold Separately)

a. Unlock the blank universal insert plate by releasing the latch in the front and remove the plate (Fig.14).

Fig. 14

b.Place downdraft table over the opening by placing the back end into the open area first.

c.The downdraft table should be seated flush against the table (Fig. 15).

d.Lock the latch of the downdraft table. If the latch cannot be locked, the table is not seated correctly. Re-position and lock.

Fig. 15