11.Tail Vise (Sold Separately) a. Locate the following parts:
(1)Clamp block (MDF), (2) Guide rods, (1) Threaded rod, (6) Bolts and (6) Bolt covers.
b. Position clamp block (MDF) over guide rods, and threaded rod as shown in figure 16
c. Securely attach guide block to the rods with (6) washer and bolts provided (Fig. 16).
d. Place one bolt cover over each screw head making sure it’s flush to the table (Fig. 16).
Fig. 16
e. Locate the following parts:
(1)Threaded rod insert (2) Guide rod inserts, (3) Insert nuts, (2) Rod blocks, (4) Screws, (4) Nuts and (1) Pin.
f. Insert rod inserts from the backside of frame completely into the three holes provided (Fig. 17).
Fig. 17
g.Secure rod inserts to frame with the three large nuts provided from the front side of frame (Fig. 18).
! | CAUTION | Make sure the orientations of the mating nuts |
are as indicated in the figures. | ||
|
| Fig. 18 |
Rod Block
h. Place the rod block from backside of frame as shown, insert two screws from the front side of frame into rod block and secure with two nuts from backside of frame. Repeat this procedure on other side of frame (Fig. 18).
i. Insert guide rods and threaded rod into nuts and rod insert making sure guide rods go thru rod blocks on each side of frame while slowly threading rod with the knob into the frame like a vise (Fig. 19).
Fig. 19
j. Once the tail vise has been threaded into rod inserts, attach the pin provided onto the end of the threaded rod (Fig. 20).
Fig. 20
k. Place the selected object between the tail vise and table edge and secure it by rotating the tail vise knob clockwise. Maximum weight load is 40lbs.
! | CAUTION | When clamping small work pieces, the tail vise | |
only works when the work piece is in the middle | |||
|
|
of the vise (Fig. 21).
Fig. 21
12. Clamping Kit (Sold Separately)
a. Dog hole clamps are placed in the dog holes to hold the work pieces in place during cutting (Fig. 22).
8.