Setup Screens
Setup Screens
Use the Setup screens to set control parameters for the motor. See
Screen Navigation and Editing, page 9 , for information on how to make selections and enter data.
Inactive fields are
Information displayed on the Setup screens corresponds to the Modbus Registers. See Appendix A - Modbus Variable Map, page 34.
NOTE: Before setting up profiles on Setup Screens
Setup Screen 1
Use this screen to set the operating mode for a selected pump and profile.
Figure 14 Setup Screen 1
Setup Screen 1 Key
Enter the screen.
Pump selection — See Step 1.
Profile selection — See Step 2.
Pressure mode or Flow mode — See Step 3
Setting for Back Pressure Regulator — See Step 4.
Press to accept the selections.
This softkey is disabled by default, and only appears if the “Profile Lock” box is checked on Setup Screen 15, page 29. Press to activate the profile just edited.
Exit the screen.
16 | 3A2527D |