Siemens L-850D/E F-Range Style 2 Inset Lights manual Label Toe-in Installation

Page 10

L-850D/E F-Range Style 2 Inset Lights

General Information and Requirements

Equipment data, continued

Toe-in coding For some applications, the inset lights are delivered with built-in toe-in. Refer to page 30 and following for detailed information.

According to this toe-in, those lights are to be installed to the left or to the right of the Runway/ Approach center line. The built-in toe-in is referenced with labels (black letters on yellow background):

	Label				Toe-in	Installation

					right	to the left of the center line when looking in the
	C.L				right	to the left of the center line when looking in the
						direction of the (main) beam



					left	to the right of the center line when looking in the
	C.L				left	to the right of the center line when looking in the
	C.L					direction of the (main) beam
						direction of the (main) beam

	No label				no	on the center line

NB: the arrow points towards the R/ W centre line.

Equipment required for installation and maintenance

Beyond the light itself, some equipment is required for installation and maintenance.

This equipment is not supplied with the light but can be purchased from Siemens Airfield Solutions.

It is listed on page 11.

 2002 Siemens Airfield Solutions, Incorporated	96A0266D	8
All rights reserved	Issued 2/02

Image 10

Contents Siemens Airfield Solutions 850D/E F-Range Style Inset Lights Record of Changes Revision Description Editor Checked DateSafety Instructions Safety precautionsWarranty Information About this Manual Parts Identification Comments and ProposalsTable of Contents General Information and Requirements Overview General information Equipment data Label Toe-in Installation Equipment required for installation and maintenanceInstallation Overview General recommendations Organisation Applicable documentsAttack driver Equipment required for installationTool case Additional tools and equipmentInstallation on FAA Deep Bases Overview UNC Installation method Step ActionHow to mount the light assembly Mounting and connectionMaintenance Overview Field maintenance Workshop maintenance and preventive maintenancePreventive maintenance Maintenance Tasks Interval Check Action PreventiveProcedure Lifting toolsServicing in the Maintenance Base Overview PreliminaryHow to open the light assembly Film disc cut-out Procedure How to replace a lampIllustration Illustration below clarifies the procedure How to replace a prism How to replace the optical assembly How to replace the cable set assembly Illustration How to close and test the light fixture Troubleshooting Problem Possible cause SolutionAssemblies and Exploded View Overview Introduction Light Assembly Part NumbersContents This chapter contains the following topics Topic SeeAssemblies Remarks850E Ordering codeRemark Film disc cutout optional 850D Ordering CodeList of tables 850D Solutions code 850EFixtures CateDescription 1411.40.xxx 000 010 020 030 040 050 060 070 080 090 100Description 1411.41.xxx 000 010 020 030 040 050 060 070Illustrations Description 200 210 220 230 240 250 260Part number 270 280 290 300 310 320 330 270 280 290 300 310 320 330 Toe-in Installation Solutions part 100 110 120 130 140 150 160 170 180Illustration below shows the 12 F-Range inner covers Screws Overview Screw Tool Loctite Torque12 L-850D/E Exploded viewRange