Siemens L-850D/E F-Range Style 2 Inset Lights manual Assemblies, Remarks

Page 32

L-850D/E F-Range Style 2 Inset Lights

Assemblies and Exploded View

Assemblies

Spare parts It is recommended to create a sufficiently large stock of spare parts to maintain the fittings. It will mainly consist of consumables like lamps, O-ring gaskets, film disc cutouts, etc. Other components that may need replacement, such as prisms, prism gaskets, terminal blocks and hardware even as sub-assemblies, should be stocked in smaller quantities. The stock should also contain some complete fittings of each type.

Ordering code The illustration below clarifies the structure of the ordering code for the FAP type.

FAP

Remarks	The toe-in applies to the red beam only.
	Film disc cutout: optional.
	NOTE: Contact Siemens Airfield Solutions Sales Department for shallow base
	mounting options.

 2002 Siemens Airfield Solutions, Incorporated	96A0266D	30
All rights reserved	Issued 2/02

Image 32

Contents Siemens Airfield Solutions 850D/E F-Range Style Inset Lights Record of Changes Revision Description Editor Checked DateSafety Instructions Safety precautionsWarranty Information About this Manual Parts Identification Comments and ProposalsTable of Contents General Information and Requirements Overview General information Equipment data Label Toe-in Installation Equipment required for installation and maintenanceInstallation Overview General recommendations Organisation Applicable documentsEquipment required for installation Tool caseAttack driver Additional tools and equipmentInstallation on FAA Deep Bases Overview UNC Installation method Step ActionHow to mount the light assembly Mounting and connectionMaintenance Overview Preventive maintenance Workshop maintenance and preventive maintenanceField maintenance Maintenance Tasks Interval Check Action PreventiveProcedure Lifting toolsServicing in the Maintenance Base Overview PreliminaryHow to open the light assembly Illustration Illustration below clarifies the procedure How to replace a lampFilm disc cut-out Procedure How to replace a prism How to replace the optical assembly How to replace the cable set assembly Illustration How to close and test the light fixture Troubleshooting Problem Possible cause SolutionIntroduction Light Assembly Part Numbers Contents This chapter contains the following topics TopicAssemblies and Exploded View Overview SeeAssemblies RemarksRemark Film disc cutout optional Ordering code850E 850D Ordering CodeList of tables Solutions code 850E Fixtures850D CateDescription 1411.40.xxx 000 010 020 030 040 050 060 070 080 090 100Description 1411.41.xxx 000 010 020 030 040 050 060 070Illustrations Part number 270 280 290 300 310 320 330 200 210 220 230 240 250 260Description 270 280 290 300 310 320 330 Toe-in Installation Solutions part 100 110 120 130 140 150 160 170 180Illustration below shows the 12 F-Range inner covers Screws Overview Screw Tool Loctite TorqueRange Exploded view12 L-850D/E