Siemens L-850D/E F-Range Style 2 Inset Lights manual General recommendations

Page 12

L-850D/E F-Range Style 2 Inset Lights

Installation

General recommendations

Receiving, storage and unpacking

Electrical connection

Location and tolerances

1.Upon receipt of goods at the site store, check all packings for visible damage. Every damaged box should be opened and its content inspected for damage.

If equipment is damaged, a claim form shall be filed with the carrier immediately. It may then be necessary for the carrier to inspect the equipment.

2.Store the light assembly preferably in its original packing in a protected area. When stored unpacked, please take care not to damage the cable insulation.

3.Unpack the light assembly at the installation site to avoid damage during transportation and handling.

The light assemblies covered by this manual are designed for connection to 6.6 or 20-A series circuits via one, two or three L-830 or L-831 isolation transformer(s).

The isolation transformers are to be ordered separately.

The applicable documents for location details and tolerances are the following:

	Organisation	Applicable documents

	ICAO	Annex 14

		Aerodrome Design Manual Part 4

	FAA	Advisory Circular AC 150/5345-46B

 2002 Siemens Airfield Solutions, Incorporated	96A0266D	10
All rights reserved	Issued 2/02

Image 12

Contents Siemens Airfield Solutions 850D/E F-Range Style Inset Lights Record of Changes Revision Description Editor Checked DateSafety Instructions Safety precautionsWarranty Information About this Manual Parts Identification Comments and ProposalsTable of Contents General Information and Requirements Overview General information Equipment data Label Toe-in Installation Equipment required for installation and maintenanceInstallation Overview General recommendations Organisation Applicable documentsEquipment required for installation Tool caseAttack driver Additional tools and equipmentInstallation on FAA Deep Bases Overview UNC Installation method Step ActionHow to mount the light assembly Mounting and connectionMaintenance Overview Workshop maintenance and preventive maintenance Field maintenancePreventive maintenance Maintenance Tasks Interval Check Action PreventiveProcedure Lifting toolsServicing in the Maintenance Base Overview PreliminaryHow to open the light assembly How to replace a lamp Film disc cut-out ProcedureIllustration Illustration below clarifies the procedure How to replace a prism How to replace the optical assembly How to replace the cable set assembly Illustration How to close and test the light fixture Troubleshooting Problem Possible cause SolutionIntroduction Light Assembly Part Numbers Contents This chapter contains the following topics TopicAssemblies and Exploded View Overview SeeAssemblies RemarksOrdering code 850ERemark Film disc cutout optional 850D Ordering CodeList of tables Solutions code 850E Fixtures850D CateDescription 1411.40.xxx 000 010 020 030 040 050 060 070 080 090 100Description 1411.41.xxx 000 010 020 030 040 050 060 070Illustrations 200 210 220 230 240 250 260 DescriptionPart number 270 280 290 300 310 320 330 270 280 290 300 310 320 330 Toe-in Installation Solutions part 100 110 120 130 140 150 160 170 180Illustration below shows the 12 F-Range inner covers Screws Overview Screw Tool Loctite TorqueExploded view 12 L-850D/ERange