Lever (10A)) and the fluid will atomize. Continue to move the Finger Lever (10A) to achieve the air volume you need for your spray technique.
7.Continue to adjust the spray volume by using the Finger Lever (10A), moving it front to back. When you have the correct spray volume, you may fix the position using the Adjustment Screw (9A).
8.The size of the spray pattern will be in accordance with the distance between the work surface and the Nozzle (3A) of the Air Brush. For
9.When you are finished painting, gently release pressure on Finger Lever (10A).
NOTE: If while using this Air Brush and fluid blocks the Nozzle (3A) from working, move Needle Chucking Guide (13A) back and forth. If this does not clear the Nozzle (3A), try loosening the Needle Adjustment Screw (9A). This will allow a longer movement for the Needle (18A) and allow the blocked fluid to escape clearing the Nozzle (3A).
10.After flushing the Air Brush unit completely with the proper solvent: Lacquer thinner if you used a lacquer paint, water if you used a latex based paint and paint thinner for all oil based enamels, spray remaining solvent through the Nozzle (3A) until clear solvent sprays from end of Airbrush tip.
NOTE: ALL paints used with this Air Brush are fast drying by design and can seriously damage your tool if they are NOT flushed immediately.
11.Bleed excess air from hose and drain water out of the Water Drain Valve (23) on the Air Compressor only after turning
OFF Power Switch (34) and unplugging the Compressor from the 120 V power supply, or from your extension cord.
NOTE: The 5cc Metal Cup (28A) has two uses. It is used for excess thinned paint, and also for solvent when it is time to clean the Air Brush.
NOTE: The Metal Hook (30A) can be attached to a solid surface and used to hang Air Brush when it is not being used.
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION, make sure Power Switch of tool is in its “Off” position and that the tool is unplugged from its electrical outlet before any maintenance or repairs are done.
Note: These procedures are in addition to the regular checks and maintenance explained as part of the regular operation of the
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrcial wiring, and any other condition that may affect
its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
2.AFTER EACH USE, wipe off with a clean, moist cloth. Also completely flush,
Page 10 | For technical questions, please call | SKU 95630 |