Assembly
Initial Tool Setup/Assembly
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are found, do not use tool until repaired.
1.Connect one end of the air hose to the Air Outlet (38).
2.Connect other end of air hose to the Air
Brush (27).
3.Inspect the air connections for leaks. Repair any leaks found.
Operating Instructions
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are found, do not use tool until repaired.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the air hose along a safe route to reach the work area without creating a
tripping hazard or exposing the air hose to possible damage. The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.
3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be hazardous objects (utility lines or foreign objects) nearby that present a hazard while working.
General Operating Instructions
1.Choose a 120V power supply and plug in Air Compressor.
2.Set the Pressure Gauge to desired air pressure (maximum 58 PSI).
3.Fill the 22cc Glass Jar (31A) after thinning your paint properly.
NOTE: Use the proper solvent for thinning. Use lacquer thinner for all lacquers, paint thinner for oil based paints, and water for all latex based paints.
4.Hold the Air Brush Housing (8A) lightly in your hand and push the tappered fitting on the lid of the 22cc Glass Jar
Assembly (31A) into the base of the Air Brush Housing (8A). It is held in place with friction and not threading.
5.Turn on the Power Switch (34) and the Air Compressor will start and work continuously until it reaches its maximum preset pressure which will be approximately 55 PSI at which time it will automatically shut down. It will
6.By pressing the Finger Lever (10A) air will emerge from the Nozzle (3A). Draw back slowly/gently on the Finger
SKU 95630 | For technical questions, please call | Page 9 |