Harbor Freight Tools 95630 Grounded Tools Tools with Three Prong Plugs, Ding Grounding

Page 6

ground fault interrupt (GFCI) system is also a good precaution. This inexpensive device is a good safety measure because it prevents a sustained electrical shock.

• Properly maintain and inspect all tools before use to avoid electrical shock

16.Never leave the tool unattended when it is plugged into an electrical outlet. Turn off the tool, and unplug it from its electrical outlet before leaving.

17.WARNING: The brass components of this product contain lead, a chemical known to the State of California

to cause birth defects (or other reproductive harm). (California Health & Safety code § 25249.5, et seq.)

18.WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contains chemicals known [to the State of California] to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

Lead from lead-based paints Crystalline silica from bricks and cement or other masonry products

Arsenic and chromium from chemically treated lumber

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (California

Health & Safety Code § 25249.5, et seq.)

19.Always maintain adequate ventilation, especially when using solvent based paints and during clean up.

SAVE THESE Groun INSTRUCTIONS.

ding Grounding

TO PREVENT ELECTRIC

SHOCK AND DEATH

FROM

INCORRECT GROUNDING WIRE CONNECTION:

Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.

Do not modify the power cord plug provided with the tool. Never remove the grounding prong from the plug. Do not use the tool if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a

qualified electrician.

Grounded Tools:

Tools with Three Prong Plugs

3-Prong Plug and Outlet

1.Tools marked with “Grounding Required” have a three wire cord and three prong grounding plug. The plug must be connected to a properly grounded outlet.

Page 6

For technical questions, please call 1-800-444-3353.

SKU 95630

Image 6
Contents Compressor AIR Brush KIT Safety Alert Symbol and Signal Words Symbol Property or statementFor technical questions, please call General Electrical SafetyPersonal safety Work areaService Tool use and careSpecificSPECIFICSafety InstructionsSAFETY S Grounded Tools Tools with Three Prong Plugs Ding GroundingProng Plug and Outlet Double Insulated Tools Tools with Two Prong Plugs Extension CordsSymbology UnpackingFunctional Description Initial Tool Setup/Assembly AssemblyWork Piece and Work Area Set Up General Operating InstructionsTo Prevent Serious Injury Troubleshooting Problem Possible Causes Likely SolutionsSKU For technical questions, please call Qty Part Description Compressor Parts List and Assembly DiagramPart Description Qty For technical questions, please callAir Brush Parts List and Assembly Diagram Part Description QtyLimited 1 Year Warranty