Harbor Freight Tools 45804 manual Assembly Instructions, To Attach The Bottom Plate

Page 11

ASSEMBLY INSTRUCTIONS

NOTE: For additional references to the parts listed in the following pages, refer to the Assembly Diagrams on pages 20 and 21 of this manual.

To Attach The Bottom Plate:

1.Turn the saw Base (188) over, and position the Bottom Plate (193) in place. (See Figure D.)

2.Line up the four holes. Secure Bottom Plate in place using the 4 cross head screws (be careful not to overtighten) that are packed in the small plastic bag included in the box.

To Install A Saw Blade:

Figure D

1.WARNING! Prior to installing a Saw Blade (3), make sure the Table Saw is disconnected from its electrical power source.

To help prevent injury, heavy work gloves are recommended when replacing the blade.

2.Unscrew the two Screws (96) located on the Cover (101), and remove the Cover to expose the Saw Blade opening. (See Figure E.)

FENCE ASSY. (75)

FIGURE E	SAW BLADE (3)
	(not included)

HEX BOLT (1)

FLAT WASHER (2) WASHER “A” (3)

SCREW (96)

COVER (101) (REMOVED)

SCREW (96)

SHAFT (#7)

SKU 45804

PAGE 11

Image 11

Contents Bench Table SAW 2 HP Assembly and Operating InformationWork Area Product SpecificationsGeneral Safety Rules Save this ManualPersonal Safety Electrical SafetyTool USE and Care Grounded Tools Tools with Three Prong Plugs ServiceGrounding Figure a Double Insulated Tools Tools with TWO Prong Plugs See Figure C, and Figure D Extension CordsSee Figure C Specific Safety Rules SymbologyNever allow the woodstock to to it Always use the proper size and type of Saw Blade UnpackingTo Attach The Bottom Plate Assembly InstructionsTo Install a Saw Blade Mounting Post To Attach The Guard AssemblySee Figure F See Figure E, previousTension Adjustment Screw To Attach The Fence AssemblySee Figure M To Adjust The Angle Of The Saw BladeOperating Instructions To Raise And Lower The Saw BladeSee Figure O, next To Adjust The Width Of a CutAssembly 75 to the right or left. See Figure M Proper Placement Of Hands During The Cutting ProcessManner. See Figure P INSPECTION, MAINTENANCE, and CleaningTable SAW Overload Protection TOP View of TablePlease Read the Following Carefully Parts List a Parts Parts List B Parts Assembly Diagram a Parts Assembly Diagram B Parts Appendix a Mounting Instructions Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty