Harbor Freight Tools 45804 Operating Instructions, To Raise And Lower The Saw Blade, See Figure M

Page 14

 

BLADE GUARD

SAW BLADE (3)

ASSY. (50)

 

(not included)

 

RULER SUPPORT

FENCE ASSY. (75)

(86)

 

GRADUATION

SCALE

LOCKING KNOB (167)

Fence Handle (80)

(LOCKED POSITION)

ANGLE INDICATOR

ANGLE

SCALE

SWITCH

CIRCUIT

WHEEL

(179)

BREAKER

 

(170)

 

(178)

 

FIGURE M

 

 

OPERATING INSTRUCTIONS

To Raise And Lower The Saw Blade:

1.When cutting, the top edge of the Saw Blade (3) should rise about 1/4” above the top edge of the workpiece.

2.To raise the height of the Saw Blade (3), unlock the Locking Knob (167) by turning it counterclockwise. Next, turn the Wheel (170) clockwise until the desired height is acquired. Then, turn the Locking Knob clockwise to lock the Saw Blade in position.

(See Figure M.)

3.To lower the height of the Saw Blade (3), unlock the Locking Knob (167) by turning it counterclockwise. Next, turn the Wheel (170) counterclockwise until the desired height is acquired. Then, turn the Locking Knob clockwise to lock the Saw Blade in position. (See Figure M.)

To Adjust The Angle Of The Saw Blade:

1.The Table Saw is capable of making cuts from 90 degrees to 45 degrees.

2.The Table Saw also features an Angle Scale and Angle Indicator on the front side of the unit. (See Figure M.)

SKU 45804

PAGE 14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Assembly and Operating Information Bench Table SAW 2 HPSave this Manual Product SpecificationsGeneral Safety Rules Work AreaElectrical Safety Personal SafetyTool USE and Care Grounded Tools Tools with Three Prong Plugs ServiceGrounding Figure a Double Insulated Tools Tools with TWO Prong Plugs See Figure C, and Figure D Extension CordsSee Figure C Symbology Specific Safety RulesNever allow the woodstock to to it Unpacking Always use the proper size and type of Saw BladeTo Attach The Bottom Plate Assembly InstructionsTo Install a Saw Blade See Figure E, previous To Attach The Guard AssemblySee Figure F Mounting PostTo Attach The Fence Assembly Tension Adjustment ScrewTo Raise And Lower The Saw Blade To Adjust The Angle Of The Saw BladeOperating Instructions See Figure MProper Placement Of Hands During The Cutting Process To Adjust The Width Of a CutAssembly 75 to the right or left. See Figure M See Figure O, nextTOP View of Table INSPECTION, MAINTENANCE, and CleaningTable SAW Overload Protection Manner. See Figure PPlease Read the Following Carefully Parts List a Parts Parts List B Parts Assembly Diagram a Parts Assembly Diagram B Parts Appendix a Mounting Instructions Limited 1 year / 90 Day warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800
Top Page Image Contents