Harbor Freight Tools 45804 manual To Attach The Fence Assembly, Tension Adjustment Screw

Page 13
FIGURE I

3.As shown in Figure I, now tighten the 4 Socket Head Screws (65) to secure the guard bracket in place.

4.To adjust the height of the

Blade Guard Assembly (50), loosen the Hex Screws (68). Raise the Guard Assembly

to the desired height. Then retighten the two Hex Screws.

See Figure J.

5.

After making any adjustments to or installing the Blade

Figure J

Guard Assembly (50), make sure that the Guard is

 

aligned properly and doesn’t contact the Blade.

To Attach The Fence Assembly:

1.CAUTION! Prior to installing the Fence Assembly (75), make sure the Table Saw is disconnected from its electrical power source.

2.To attach Fence Assembly (75) to the Table (105), raise the Fence Handle (80) to a horizontal position. Slip the Front Board (94) of the fence over the front edge of the Table. (See

Figure K)

3.Slip the rear Clamp (89) of the Fence Assembly onto the top/rear edge of the Table, lowering the Fence Assembly all the way onto the Table (105).

Then, lock the Fence Assembly in position by

lowering the Fence Handle to a vertical position. Figure K (See Figure L)

Tension

Adjustment

Screw

BLADE GUARD ASSY. (50)

FENCE ASSY. (75)

 

Fence Handle (80)

(UNLOCKED POSITION)

FIGURE L

SKU 45804

PAGE 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Bench Table SAW 2 HP Assembly and Operating InformationGeneral Safety Rules Product SpecificationsSave this Manual Work AreaPersonal Safety Electrical SafetyTool USE and Care Grounding ServiceGrounded Tools Tools with Three Prong Plugs Figure a Double Insulated Tools Tools with TWO Prong Plugs See Figure C Extension CordsSee Figure C, and Figure D Specific Safety Rules SymbologyNever allow the woodstock to to it Always use the proper size and type of Saw Blade UnpackingTo Install a Saw Blade Assembly InstructionsTo Attach The Bottom Plate See Figure F To Attach The Guard AssemblySee Figure E, previous Mounting PostTension Adjustment Screw To Attach The Fence AssemblyOperating Instructions To Adjust The Angle Of The Saw BladeTo Raise And Lower The Saw Blade See Figure MAssembly 75 to the right or left. See Figure M To Adjust The Width Of a CutProper Placement Of Hands During The Cutting Process See Figure O, nextTable SAW Overload Protection INSPECTION, MAINTENANCE, and CleaningTOP View of Table Manner. See Figure PPlease Read the Following Carefully Parts List a Parts Parts List B Parts Assembly Diagram a Parts Assembly Diagram B Parts Appendix a Mounting Instructions Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty
Top Page Image Contents