Harbor Freight Tools 92386 manual Figure K

Page 16

6.Plug the Power Cord Plug (20) into the nearest 120 volt, grounded, electrical outlet, making sure to form a “drip loop” with the Power Cord. (See Figure D, page 9.)

7.Turn the Power Switch (37) to its “ON” position, and allow the Saw Blade (4) to spin up to full speed. (See Figure K.)

CIRCUIT BREAKER

(32)

POWER SWITCH

(37)

FIGURE K

8.Adjust the Flow Control Knob on the Water Pump (7) until the water reaches the edge of the Saw Blade (4), just before the Saw Blade would contact the tile being cut. Make sure the Water Pump is supplying a continuous flow of water to the Saw Blade. (See Figure I, page 15.)

TILE

 

HANDLE I

 

 

(38)

TABLE (44)

SAW BLADE

(4)

FIGURE L

9.Hold the tile firmly against the Angle Cutting Guide and Scale Rail (49) with one hand. Always keep fingers a safe distance away from the Blade (4). With the other hand, hold the Handle I (38) and slowly move the Saw Blade forward over the tile. (See Figure L.)

REV 12/06

SKU 92386

For technical questions, please call 1-800-444-3353.

Page 16

Image 16
Contents For technical questions or replacement parts, please call HP Tile SAWProduct Specifications General Safety RulesSave this Manual UnpackingPersonal Safety Electrical SafetyWork Area Tool USE and Care Service GroundingSee Figure B, next See Figure B120 or 240 Volt Nameplate Extension Cord LengthAt full load Specific Safety Rules Figure C Industrial applications must follow Osha requirements Never attempt to cut more than one tile at a timeAssembly Instructions See Figure F TOP ViewWheel Assembly See Figure H Operating InstructionsSee Figure I, next To Make a Straight Cut See Figure JFigure K See Figure K, See Figure K, page 16 and Figure L,To Change The Saw Blade See Figure P, next SKU For technical questions, please callFigure P See Figures P and QFigure R INSPECTION, MAINTENANCE, and Cleaning Please Read the Following Carefully Parts List Part DescriptionFoot Pad Assembly Diagram