Harbor Freight Tools 92386 manual Figure R

Page 20

6.Install a new Saw Blade (4). Always use Diamond Saw Blades with a 7” diam- eter, 5/8” round arbor hole, and rated at 3550 RPM or greater.

(See Figure P, previous page.)

7.IMPORTANT: When installing a Saw Blade (4), make sure the “ARROW” de- picted on the side of the Saw Blade points in the same direction as that of the Blade Guard (12). (See Figure R.)

8.Once the Saw Blade (4) is installed, refasten the Outside Flange (5) and Nut (6). Make sure to tighten the Nut fully before using the Tile Saw.

(See Figure P, previous page.)

9.Carefully lower the Blade Guard (12) back into its original position. Then secure the Blade Guard in place using the Bolts (91), Spring Washers (89), and Washers (88). (See Figure S.)

SAW BLADE (4)

BLADE GUARD (12)

ARROW

ARROW

 

 

 

 

 

 

 

 

FIGURE R

BOLT (91) SPRING WASHER (89)

WASHER (88)

BOLT (91)

SPRING WASHER (89) WASHER (88)

FIGURE S

SKU 92386

For technical questions, please call 1-800-444-3353.

Page 20

Image 20
Contents For technical questions or replacement parts, please call HP Tile SAWProduct Specifications General Safety RulesSave this Manual UnpackingWork Area Electrical SafetyPersonal Safety Tool USE and Care Service GroundingSee Figure B, next See Figure BAt full load Nameplate Extension Cord Length120 or 240 Volt Specific Safety Rules Figure C Industrial applications must follow Osha requirements Never attempt to cut more than one tile at a timeAssembly Instructions See Figure F TOP ViewWheel Assembly See Figure I, next Operating InstructionsSee Figure H To Make a Straight Cut See Figure JFigure K See Figure K, See Figure K, page 16 and Figure L,To Change The Saw Blade See Figure P, next SKU For technical questions, please callFigure P See Figures P and QFigure R INSPECTION, MAINTENANCE, and Cleaning Please Read the Following Carefully Parts List Part DescriptionFoot Pad Assembly Diagram