Harbor Freight Tools 92386 manual See Figure B, next

Page 6

4.Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See Figure A.)

FIGURE A

Extension Cords

1.Grounded tools require a three wire extension cord. Double Insulated tools can use either a two or three wire extension cord.

2.As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a seri- ous drop in voltage, resulting in loss of power and possible tool damage.

(See Figure B, next page.)

3.The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry a higher current than a 16 gauge cord.

(See Figure B.)

4.When using more than one extension cord to make up the total length, make sure each cord contains at least the minimum wire size required. (See Figure B.)

5.If you are using one extension cord for more than one tool, add the nameplate am- peres and use the sum to determine the required minimum cord size.

(See Figure B.)

6.If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.

7.Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electri- cian before using it.

8.Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.

REV 03/05

SKU 92386

For technical questions, please call 1-800-444-3353.

Page

Image 6
Contents For technical questions or replacement parts, please call HP Tile SAWSave this Manual Product SpecificationsGeneral Safety Rules UnpackingElectrical Safety Personal SafetyWork Area Tool USE and Care Service GroundingSee Figure B, next See Figure BNameplate Extension Cord Length 120 or 240 VoltAt full load Specific Safety Rules Figure C Industrial applications must follow Osha requirements Never attempt to cut more than one tile at a timeAssembly Instructions See Figure F TOP ViewWheel Assembly Operating Instructions See Figure HSee Figure I, next To Make a Straight Cut See Figure JFigure K See Figure K, See Figure K, page 16 and Figure L,To Change The Saw Blade See Figure P, next SKU For technical questions, please callFigure P See Figures P and QFigure R INSPECTION, MAINTENANCE, and Cleaning Please Read the Following Carefully Parts List Part DescriptionFoot Pad Assembly Diagram