Harbor Freight Tools 97099 operating instructions Figure S

.Turn the Coolant Pump Fitting (91S) to its “OPEN” position. Then turn the Coolant Pump Toggle Switch (750S2) to its “ON” position. (See Figure S.)

.Turn the Motor Toggle Switch (750S4) to its “ON” position. (See Figure S.)

7.Set the workpiece on the Vertical Saw Table (55-2), making sure to keep downward pressure on the workpiece throughout the cutting process. (See

Figure S.)

.When cutting a large workpiece, make sure its entire length is properly supported. If necessary, use a roller stand (not included) with a large workpiece.

9.Allow the Saw Blade (251) to turn up to full speed before feeding the workpiece into the Blade. (See Figure S.)

10.Feed the workpiece into the Saw Blade (251) gradually. Do not force the Bandsaw to remove material faster than it is designed to cut. (See Figure S.)

FIGURE S

SAW HEAD ASSY.

COOLANT PUMP FITTING (91S)

SAW BLADE (251)

VERTICAL SAW TABLE (55-2)

MOTOR TOGGLE SWITCH (750S4)

COOLANT PUMP TOGGLE SWITCH (750S2)

CYLINDER (216)

SKU 97009 For technical questions, please call 1-800-444-3353. Page 22