.Plug the Power Cable (500) into the nearest 120 volt, grounded, electrical outlet. NOTE: If the Bandsaw has been
7.Turn the Coolant Pump Fitting (91S) to its “OPEN” position. Then turn the Coolant Pump Toggle Switch (750S2) to its “ON” position. (See Figure T.)
.Turn the Motor Toggle Switch (750S4) to its “ON” position. (See Figure T.)
9.Turn the Cylinder to its “ON” position, and slowly lower the Saw Head until the Saw Blade (251) is just above the workpiece cut line. (See Figure T.)
10.Allow the Saw Blade (251) to turn up to full speed before feeding the Blade into the workpiece. (See Figure T.)
11.Through the Hydraulic Feed System, allow the Saw Arm to lower, while it gradually feeds the Saw Blade (251) into the workpiece. Do not force the Bandsaw to remove material faster than it was designed to cut. NOTE: The speed at which the Saw Arm moves downward may be increased or decreased by adjusting the Bleed Valve on the Cylinder (216). (See Figure T.)
12.Never attempt to remove material stuck in the moving parts of the Bandsaw while it is plugged in and running. Turn off the Bandsaw if the workpiece is to be backed out of an uncompleted cut.
COOLANT PUMP FITTING
(91S)
SAW HEAD ASSY.
FIGURE T
MOTOR |
|
TOGGLE SWITCH | CYLINDER (216) |
(750S4) |
COOLANT PUMP TOGGLE
SWITCH
(750S2)
SKU 97009 | For technical questions, please call | Page 24 |