
Dolphin Demo Main Screen
When you start the program, this menu screen will be the first one you see. This screen allows you to access the demonstration programs listed or exit to DOS. All the Demo programs will return to this menu screen when exited.
If there is no keyboard activity over a short period of time, press any key to go to the Dolphin Demo Main Screen.
F1 - Decoding Demo
Press F1 and the Scan a Target screen shown below will display:
Scan a Target
F3-Setup
H-Help
For optimal scanning performance for your application, the 2D imager has three scanning modes: standard omni, reduced omni and Advanced Linear Decoding (ALD).
To scan a bar code:
1.Press and hold the ON/SCAN button.
2.You will see the scanner alternate between a thin green aiming line, and a general red flash. The flash is when the imager is actually taking an image and attempting to decode any barcodes in the image.
3.After the Dolphin successfully decodes a barcode, the Decoded Message screen shown below will display.
UPC
C7771104501
The top of the screen tells the name of the symbology decoded, the bottom of the screen tells the length of the data decoded, and the middle section shows the message. If the message is long, you can scroll up and down using the F1 & F2 keys to read the data. To scan again, just press the ON/ SCAN button again.
3.To exit demo, press F4 and you will return to the Dolphin Demo Screen.
5 - 4 | Dolphin® 7200 User’s Guide |