Planar WS231 manual Power Management System, Connecting the LCD Monitor to the PC

Page 11

User’s Manual

Figure 1-5: Connecting the LCD Monitor to the PC

3.If your PC has a graphic card with a 24-pin DVI connector, you may connect it with the Digital 24-pin DVI signal cable.

4.Make sure the signal cable head is securely connected to the VGA port of your PC. Tighten the connecting screws to ensure a secure connection.

If both analog (15-pin D-sub VGA) and digital (24-pin DVI) input ports are connected at the same time, the signal input can be selected with the port select button. Please go to the next chapter for details.

Power Management System

The LCD Monitor complies with the VESA DPMS (version 1.0p) power management proposal. The VESA DPMS proposal provides four phases of power saving modes by detecting the horizontal or vertical sync signal. When the LCD Monitor is in power saving mode or detects an incorrect timing, the Monitor screen will go blank, and the power LED indicator will start to blink.

Image 11

Contents WS231 Preface Radio Frequency Interference Statement Important Safety Instructions Table of Contents Unpacking LCD MonitorYour new LCD Monitor LCD Monitor Front View Identifying ComponentsLCD Monitor Rear View User’s Manual Power Button and Port SelectConnecting AC Power Adjusting the Viewing AngleConnecting Power to the LCD Monitor Connecting VideoConnecting the LCD Monitor to the PC Power Management SystemLCD Monitor’s Display Controls Analog Input Mode use 15 pin VGA portDisplay Controls Geometric sub Menu DescriptionOSD Adjust sub Menu OSD Adjust sub Menu6500 Color temp. Sub MenuDigital Input Mode use 24 pin DVI port OSD Adjust sub Menu Hotkey descriptions When there is no input signalTechnical Information TFT LCD Monitor SpecificationsScanning Frequency Supported Timing Timing for Model FMT2315U Uxga ResolutionSUN Troubleshooting Procedures TroubleshootingProblem There is no LCD Display 6200507210