Planar WS231 manual LCD Monitor Rear View, User’s Manual Power Button and Port Select

Page 8

User’s Manual

4.Power Button and Port Select

Push the button to turn the Monitor ON or OFF (push and hold the button for 2 seconds to switch between Analog or Digital input mode).

5.Power-On Indicator

This LED indicator lights when the power is on. The LED indicator will blink when the LCD Monitor is in Power Saving mode.

The LCD Monitor — Rear View

Figure 1-2: LCD Monitor’s Rear Ports

1.Input signal ports

The monitor has one 15-pin D-sub VGA connector and one 24-pin DVI connector (optional), the 24-pin DVI connector is for Digital signal if your PC has a graphic card with DVI connector.

2.USB port (Optional)

Connect the USB cable from this port to PC HOST.

3.DC Power Jack

Connect the AC power Adapter output cable to this connector

3

Image 8
Contents WS231 Preface Radio Frequency Interference Statement Important Safety Instructions Table of Contents Unpacking LCD MonitorYour new LCD Monitor Identifying Components LCD Monitor Front ViewUser’s Manual Power Button and Port Select LCD Monitor Rear ViewAdjusting the Viewing Angle Connecting AC PowerConnecting Video Connecting Power to the LCD MonitorPower Management System Connecting the LCD Monitor to the PCLCD Monitor’s Display Controls Analog Input Mode use 15 pin VGA portDisplay Controls Description Geometric sub MenuOSD Adjust sub Menu OSD Adjust sub MenuColor temp. Sub Menu 6500Digital Input Mode use 24 pin DVI port OSD Adjust sub Menu When there is no input signal Hotkey descriptionsTFT LCD Monitor Specifications Technical InformationScanning Frequency Timing for Model FMT2315U Uxga Resolution Supported TimingSUN Troubleshooting Troubleshooting ProceduresProblem There is no LCD Display 6200507210