Planar WS231 manual Hotkey descriptions, When there is no input signal

Page 18

User’s Manual

(Analog mode)

(Digital mode)

Figure 2-9: When there is no input signal

The hotkey descriptions

Figure 2-10: The Hotkeys

1.Main Menu pop up /Auto-Adjust Hotkey Press this button to activate the OSD Main Menu. Press and hold this button for 2 seconds to activate the Auto Adjust feature.

2.Contrast Adjust Hotkey

Press this button to activate the Contrast Adjust function, use -/+ adjustment control buttons to increase or decrease the display’s contrast.

3.Brightness Adjust Hotkey

Press this button to activate the Brightness Adjust function, use -/+ adjustment control buttons to increase or decrease display brightness.

Figure 2-11

Figure 2-12

Figure 2-13

4.Port Select/Power switch Hotkey

Press and release this button immediately to select either Digital or Analog input mode. Press and hold this button for 2 seconds to power on or power off the monitor.

13

Image 18
Contents WS231 Preface Radio Frequency Interference Statement Important Safety Instructions Table of Contents LCD Monitor Your new LCD MonitorUnpacking Identifying Components LCD Monitor Front ViewUser’s Manual Power Button and Port Select LCD Monitor Rear ViewAdjusting the Viewing Angle Connecting AC PowerConnecting Video Connecting Power to the LCD MonitorPower Management System Connecting the LCD Monitor to the PCAnalog Input Mode use 15 pin VGA port Display ControlsLCD Monitor’s Display Controls Description Geometric sub MenuOSD Adjust sub Menu OSD Adjust sub MenuColor temp. Sub Menu 6500Digital Input Mode use 24 pin DVI port OSD Adjust sub Menu When there is no input signal Hotkey descriptionsTFT LCD Monitor Specifications Technical InformationScanning Frequency Timing for Model FMT2315U Uxga Resolution Supported TimingSUN Troubleshooting Troubleshooting ProceduresProblem There is no LCD Display 6200507210