Planar WS231 manual Important Safety Instructions

Page 4

User’s Manual

Important Safety Instructions

Please read the following instructions carefully. This manual should be retained for future use.

1.To clean the LCD Monitor screen, first, make sure the Monitor is in the power off mode. Unplug the Monitor from its power source before cleaning it. Do not spray liquid cleaners directly onto the unit. Stand away from the LCD Monitor and spray cleaning solution onto a rag. Without applying excessive pressure, clean the screen with the slightly dampened rag.

2.Do not place your LCD Monitor near a window. Exposing the Monitor to rain, water, moisture or sunlight can severely damage it.

3.Do not place anything on top of the Monitor-to-PC signal cord. Make sure the cord is placed in an area where it will not be stepped on.

4.Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.

5.Do not remove the cover or attempt to service this unit by yourself. You may void the warranty. Servicing of any nature should be performed only by an authorized technician.

6.Safe storage of the LCD Monitor is in a range of minus 20 to plus 65 degrees Celsius (-4°F-149°F). Storing your LCD Monitor outside this range could result in permanent damage.

7.If any of the following occurs, immediately unplug your Monitor and call an authorized technician.

The power or Monitor-to-PC signal cord is frayed or damaged.

Liquid has been spilled onto the Monitor, or it has been exposed to rain.

The Monitor has been dropped or the case has been damaged.

8.The appliance should be disconnected from the mains by pulling the mains power cord/mains plug.

9.The socket-outlet shall be installed near the equipment and shall be easily accessible.

iii

Image 4
Contents WS231 Preface Radio Frequency Interference Statement Important Safety Instructions Table of Contents Your new LCD Monitor LCD MonitorUnpacking Identifying Components LCD Monitor Front ViewUser’s Manual Power Button and Port Select LCD Monitor Rear ViewAdjusting the Viewing Angle Connecting AC PowerConnecting Video Connecting Power to the LCD MonitorPower Management System Connecting the LCD Monitor to the PCDisplay Controls Analog Input Mode use 15 pin VGA portLCD Monitor’s Display Controls Description Geometric sub MenuOSD Adjust sub Menu OSD Adjust sub MenuColor temp. Sub Menu 6500Digital Input Mode use 24 pin DVI port OSD Adjust sub Menu When there is no input signal Hotkey descriptionsTFT LCD Monitor Specifications Technical InformationScanning Frequency Timing for Model FMT2315U Uxga Resolution Supported TimingSUN Troubleshooting Troubleshooting ProceduresProblem There is no LCD Display 6200507210