Planar WS231 manual Problem There is no LCD Display

Page 24

PROBLEM: There is no LCD Display

If there is no display on the LCD, please perform the following steps:

1.Make sure that the power indicator on the LCD Monitor is lit, all connections are secure, and the system is running on the correct timing. Refer to the Addendum for information on timing.

2.Turn off the LCD Monitor and then turn it back on again. Press the upper Function Control button (refer to Chapter 2) once and then press either the upper or lower Adjustment Control button several times. If there is still no display, press the other Adjustment Control button several times.

3.If step 2 doesn’t work, connect your PC system to another external CRT Monitor. If your PC System function properly with a CRT Monitor but it does not function with the LCD Monitor and the LCD Monitor’s power LED is blinking, the output timing of the PC’s VGA card may be out of the LCD’s synchronous range. Please change to an alternate mode listed in Addendum or replace the VGA card and repeat steps 1 and 2.

4.If the PC (or Notebook PC) doesn’t function with the CRT monitor neither, check BIOS to see if there is a Simultaneous Display setting under the display mode item. Set the BIOS display mode to Simultaneous Display or CRT and try again. If there is still no display, then there may be a problem with your system. Contact technical support.

5.If the power LED is not lit, check to see if the AC power connector is securely connected. If the power LED is not lit, please contact your dealer for assistance.

19

Image 24
Contents WS231 Preface Radio Frequency Interference Statement Important Safety Instructions Table of Contents LCD Monitor Your new LCD MonitorUnpacking Identifying Components LCD Monitor Front ViewUser’s Manual Power Button and Port Select LCD Monitor Rear ViewAdjusting the Viewing Angle Connecting AC PowerConnecting Video Connecting Power to the LCD MonitorPower Management System Connecting the LCD Monitor to the PCAnalog Input Mode use 15 pin VGA port Display ControlsLCD Monitor’s Display Controls Description Geometric sub MenuOSD Adjust sub Menu OSD Adjust sub MenuColor temp. Sub Menu 6500Digital Input Mode use 24 pin DVI port OSD Adjust sub Menu When there is no input signal Hotkey descriptionsTFT LCD Monitor Specifications Technical InformationScanning Frequency Timing for Model FMT2315U Uxga Resolution Supported TimingSUN Troubleshooting Troubleshooting ProceduresProblem There is no LCD Display 6200507210