INDICATION
MANDATORYINFORMATION INSTRUCTION
WARNINGPROHIBITION
These signs will give advise for your safety
Before leaving our factory every machine is thoroughly tested.
Follow our instructions strictly and your machine will give you long service in normal operating conditions.
1. Features
Use: Sawing of any kind of tile, up to 19” (482mm); diagonal of 13” x 13” (330 x 330mm) tile.
Tools: All accessories come standard with your saw; including a 10” (254mm) continuous rim Diamond Blade &
Blade Capacity: | Ø 10″ (250 mm) |
| Bore 5/8″ (15.9 mm). |
Blade Rotation: | |
Depth of Cut: | |
Cutting Length: 19″ (48.3cm)
Blade Cooling: Water pump
Horsepower: | |
Voltage: | 120 Volts, 60 Hertz, |
Amperage: | 15 amps (Full Load) |
Blade Shaft RPM: 2800 | |
Weight lbs. (kg.): | 112 (50.8) |
Dimensions (L x W x H):
Pan Holding Capacity: 5.3 gallons (20 liters)
Before starting up the machine, make sure you read this entire manual and are familiar with the operation of this machine.
The working area must be completely clear, well lit and all safety hazards removed.
The operator must wear protective clothing appropriate to the work he is doing.
Any persons not involved in the work should leave the area.
Use only blades marked with a maximum speed greater than the blade shaft speed.
2. Benefits
Your FELKER tile saw is a ruggedly constructed unit engineered to give long, satisfactory performance. Simple, daily maintenance and care will add to the life and productivity of your tile saw.
•Full
•Has a durable polymer cutting table – able to handle almost any cutting job due to its reinforced construction.
•Removable extension can also be fastened to side of cart for holding wide material.
•Cutting table designed to drain water quickly back into the water tray for efficient recycling of water.
•Cast blade guard will hinge to allow easy removal of cutting blade. Accepts up to 12” diameter blade.
•Cutting table runs on nylon wheels for smooth and accurate cuts and easy maintenance.
•Water tray of durable polymer construction to resist rust and to drain water and sediment much faster.
3. Machine Set-Up
Follow all of the assembly and installation instructions completely before connecting this saw to a power source.
UNPACKING
(Fig 1 – page 11 & Fig’s 3 & 4 – page 12) Carefully open the container and remove all the saw components and packing materials. Be certain you have checked each item with the checklist below before discarding the container or the packing materials. The contents are as follows:
1. | Operator’s Manual | 6. | Blade – 10” [250mm] |
2. | Cutting Head Assy | 7. | Water Pump, 115V/60 |
3. | Frame w/Cart | 8. | Motor Support Shaft |
4. | Water Tray | 9. | |
5. | Blade Guard | 10. | Rip Guide |
11.Accessories: Cart Extension, Bullnose Miter, Dual 45° Miter & Adj. Protractor
NOTE: IF ANY OF THE PARTS ARE MISSING OR DAMAGED PLEASE CONTACT YOUR FELKER CUSTOMER SERVICE FOR INSTRUCTIONS. CALL
10