Porter-Cable 70-200 instruction manual

Page 12

3.Assemble worm gear (J) Fig. 4, to the inside of hole

(K) in table bracket (H).

4.Thread table lock lever (M) Fig. 4, into hole in table bracket, as shown.

K

M

5.Place raising rack (E) Fig. 5, in position inside table bracket (H) making sure gear on inside of table bracket is engaged with teeth of raising rack.

6.Slide table bracket (H) Fig. 6, with raising rack (E) onto column (A), as shown.

7.Engage bottom of rack (E) Fig. 6, with flange (L) on column. Tighten table lock lever to lock table bracket (H) to column.

H

J

Fig. 4

H

E

Fig. 5

E

H

A

L

Fig. 6

12

Image 12
Contents Drill Press Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety InstructionsStay ALERT, Watch What YOU are DOING, USE of this Tool can GenerateAdditional Specific Safety Rules Failure to Follow These Rules MAY Result in Serious InjuryPower Connections Motor SpecificationsGrounding Instructions Volt Single Phase Operation Extension CordsFunctional Description ForewordCarton Contents Assembly Mounting the MachineAssembling Drill Press Page Page Chuck KEY Operational Controls and Adjustments START/STOP Controls Locking Switch OFF PositionOperation Spindle SpeedsAdjusting Spindle Return Spring Should not Contact Spring Housing a When TightDrilling Holes to Depth From ShaftTable Adjustments Removing Chuck and Spindle AdapterMachine USE Correct Drilling SpeedsBoring in Wood Troubleshooting Maintenance Drilling MetalService AccessoriesWarranty Canadian PORTER-CABLE Delta Service Centers