Porter-Cable 70-200 instruction manual

Page 13

8.Reassemble collar (D) Fig. 7, which was removed in STEP 1, to column. IMPORTANT: Bottom of collar (D) MUST NOT be pushed all the way down onto top of raising rack (E). MAKE SURE top of raising rack (E) is under bottom of collar (D) and that there is enough clearance to allow rack (E) to rotate around the column. Then tighten set screw (Q) being careful not to overtighten.

D

E

Q

Fig. 7

F

S

G

H

9.Assemble table (G) Fig. 8, to table bracket (H) using bolt (F). Line up hole (S) in table with hole in table bracket and insert pin (P) Fig. 9.

10.Assemble table raising and lowering handle (N) Fig. 10, to shaft on table bracket. Line up flat on shaft with screw (O) and tighten screw (O).

Fig. 8

P

Fig. 9

O

N

Fig. 10

13

Image 13
Contents Drill Press Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsImportant Safety Instructions General Safety RulesStay ALERT, Watch What YOU are DOING, USE of this Tool can GenerateFailure to Follow These Rules MAY Result in Serious Injury Additional Specific Safety RulesMotor Specifications Power ConnectionsGrounding Instructions Extension Cords Volt Single Phase OperationForeword Functional DescriptionCarton Contents Mounting the Machine AssemblyAssembling Drill Press Page Page Chuck KEY Locking Switch OFF Position Operational Controls and Adjustments START/STOP ControlsOperation Spindle SpeedsShould not Contact Spring Housing a When Tight Adjusting Spindle Return SpringDrilling Holes to Depth From ShaftRemoving Chuck and Spindle Adapter Table AdjustmentsCorrect Drilling Speeds Machine USEBoring in Wood Drilling Metal Troubleshooting MaintenanceAccessories ServiceWarranty Canadian PORTER-CABLE Delta Service Centers