TABLE ADJUSTMENTS
1.The table can be raised or lowered on the column by loosening table clamp handle (A) Fig. 29, and turning the table raising and lowering handle (B). After the table is at the desired height, tighten handle (A).
2.The table can be tilted right or left by pulling out and removing table alignment pin (C) Fig. 30, and loosening table locking bolt (D). Tilt the table to the desired angle and tighten bolt (D). A tilt scale and pointer are provided on the table bracket casting to indicate the degree of tilt. When returning table to the level position, replace table alignment pin (C) Fig. 30. This will automatically position the table surface at 90 degrees to the spindle.
REMOVING CHUCK AND SPINDLE ADAPTER
If you desire to remove the chuck and spindle adapter, lower spindle and rotate chuck until the slot in the spindle lines up with the slot in the quill, as shown in Fig. 31. Then insert tapered end of drift bar (A) into slot
(B) in quill and remove chuck and spindle adapter.
D
C
Fig. 30
B
A
Fig. 31
17