Porter-Cable 70-200 instruction manual Assembling Drill Press

THE PLYWOOD BASE MUST BE SECURED TO THE FLOOR OR SUPPORTING SURFACE IF THERE IS ANY TENDENCY OF THE DRILL PRESS TO VIBRATE, SLIDE OR WALK DURING NORMAL OPERATION.

ASSEMBLING THE

DRILL PRESS

1.Assemble column (A) Fig. 2, to base (B) using four M

12x 45mm long hex head screws (three of which are shown at [C]). Loosen set screw in collar (D) and remove collar (D) and raising rack (E).

2.Remove bolt (F) Fig. 3, and remove table (G) from table bracket (H).

H

GF

Fig. 3

D

E

A

B

C

Fig. 2

11