Porter-Cable 4212, 4210 instruction manual SLANTED-SIDE Joints

Page 33

MAKE ANGLED CUT

ANGLE BETWEEN BOARDS

	INSIDE	OUTSIDE
	SURFACE	OUTSIDE
	SURFACE	SURFACE
	OF BOARD	OF BOARD

Fig. 57A

SLANTED-SIDE JOINTS

Two boards joined at 90°, with one board slanted to the side is known as a slanted-side joint. This method is used to make a box with the ends at right angles to the table, but with the sides tilted outward (cradles, planters, magazine racks).

Fig. 58A

Fig. 58B

NOTE: Usually, the tails are cut into the ends and the pins are cut into the sides.

CUTTING THE TAILS

Step 1 -

Step 2 -

Step 3 -

Cut the ends of the tail board at the desired angle. Note that when the angle is approaching 15° that the tails weaken (Fig. 59A).

Mount the board so that the outside surface faces the base of the jig and the edge is against the template (Fig. 59B).

Cut the tails in the same manner as you would the standard dovetails.

Fig. 59A

Fig. 59B

33

Image 33

Contents Supplementary Instructiondovetail JIG Manual Table of Contents Important Safety Instructions Safety Guidelines DefinitionsAdditional Safety Rules Replacement PartsBackground Information Miscellaneous Techniques OperationSetup Templates Mounted to Clamping BoardsTHROUGH-DOVETAILS with Clamping Boards Cutting the Tails Cutting the PinsFitting the Joint THROUGH-DOVETAILS with Unlimited Board WidthSet the router bit depth, using the pencil mark from Step Fitting the joint is identical to the previous section a Blind Dovetails with Tail Boards Thicker than 7/8 HALF-BLIND Dovetails with Clamping BoardsWood Grain Cutting the JointUsing a Router Table Alternate Router Bits THROUGH-DOVETAIL BitsTHROUGH-DOVETAIL BIT Combinations Readily Available HALF-BLIND Dovetail BIT Readily Available BOX Joint Bits BOX Joint Bits Readily AvailableDovetail Dado Bits HALF-BLIND Dovetails with Tail Boards Thicker than 7/8 Mitered THROUGH-DOVETAIL Mitering the PinsMitering the Tails THROUGH-DOVETAIL, SKIPPED-PIN MethodHALF-BLIND DOVETAIL, Skipped PIN Method Cutting the Pins SAW Kerf Allowance Method Cutting the Tails END-TO-END Joints Multiple Spacer MethodFitting and Cutting the Joint BOX END-TO-END JointsDovetail END-TO-END Joints Drawers with Dovetail DadosHinges with a Drilled Hole Wooden HingesHinges with ROUTER-MADE Grooves Hinges with ROUTER-MADE Grooves Setup with the Template Mounted to the Base of the JIG Angled JointsObtuse Angled Joints Cutting the Tails Setup with the Template Mounted to a Clamping BoardCutting the Pins Acute Angled Joints SLANTED-SIDE Joints COMPOUND-ANGLE Joints Setup Blade Tilt Angle Make Angled CUT Inlayed Joints Inlayed Through DovetailMake the First Joint Inlayed HALF-BLIND Dovetail CUT OFF the Inlay BoardMake the Second Joint 100 13/128 050 042 028 014 Inlayed BOX Joint Through Dovetail Router BIT Combinations Tables of Commonly Available Router BIT SizesHALF-BLIND Dovetail Bits BOX Joint BIT CombinationsTroubleshooting Maintenance ServiceAccessories PORTER-CABLE Limited ONE Year Warranty WarrantyMichigan Canadian PORTER-CABLE Delta Service Centers