Porter-Cable 4210 Inlayed HALF-BLIND Dovetail, CUT OFF the Inlay Board, Make the Second Joint

Page 38

CUT OFF THE INLAY BOARD

After the joint has dried, cut the inlay board to an amount equal to the thickness of the inlay (Fig. 68B).

Fig. 68A

Fig. 68B

If desired, you can cut off the small area shown from the remainder of the inlay wood (Fig. 68C). If left on, the completed joint will have an extra amount of material on the inside. another alternative is to bevel this extra material (Fig. 68D).

Fig. 68C

Fig. 68D

MAKE THE SECOND JOINT

Make the second joint the same way as you would a standard through dovetail. HINT: Do not move the offset guides after making the first joint.

Fig. 69A

Fig. 69B

INLAYED HALF-BLIND DOVETAIL

Make this joint by producing two half-blind dovetails on top of each other.

Fig. 70B

38

Image 38

Contents Supplementary Instructiondovetail JIG Manual Table of Contents Safety Guidelines Definitions Important Safety InstructionsBackground Information Additional Safety RulesReplacement Parts Operation Miscellaneous TechniquesTHROUGH-DOVETAILS with Clamping Boards SetupTemplates Mounted to Clamping Boards Cutting the Pins Cutting the TailsTHROUGH-DOVETAILS with Unlimited Board Width Fitting the JointSet the router bit depth, using the pencil mark from Step Fitting the joint is identical to the previous section a HALF-BLIND Dovetails with Clamping Boards Blind Dovetails with Tail Boards Thicker than 7/8Cutting the Joint Wood GrainUsing a Router Table THROUGH-DOVETAIL BIT Combinations Readily Available Alternate Router BitsTHROUGH-DOVETAIL Bits HALF-BLIND Dovetail BIT Readily Available Dovetail Dado Bits BOX Joint BitsBOX Joint Bits Readily Available HALF-BLIND Dovetails with Tail Boards Thicker than 7/8 Mitering the Pins Mitered THROUGH-DOVETAILTHROUGH-DOVETAIL, SKIPPED-PIN Method Mitering the TailsHALF-BLIND DOVETAIL, Skipped PIN Method Cutting the Pins SAW Kerf Allowance Method Cutting the Tails Fitting and Cutting the Joint Multiple Spacer MethodEND-TO-END Joints BOX END-TO-END JointsDrawers with Dovetail Dados Dovetail END-TO-END JointsWooden Hinges Hinges with a Drilled HoleHinges with ROUTER-MADE Grooves Hinges with ROUTER-MADE Grooves Obtuse Angled Joints Setup with the Template Mounted to the Base of the JIGAngled Joints Setup with the Template Mounted to a Clamping Board Cutting the TailsCutting the Pins Acute Angled Joints SLANTED-SIDE Joints COMPOUND-ANGLE Joints Setup Blade Tilt Angle Make Angled CUT Make the First Joint Inlayed JointsInlayed Through Dovetail Make the Second Joint Inlayed HALF-BLIND DovetailCUT OFF the Inlay Board 100 13/128 050 042 028 014 Inlayed BOX Joint HALF-BLIND Dovetail Bits Tables of Commonly Available Router BIT SizesThrough Dovetail Router BIT Combinations BOX Joint BIT CombinationsAccessories Troubleshooting MaintenanceService Warranty PORTER-CABLE Limited ONE Year WarrantyCanadian PORTER-CABLE Delta Service Centers Michigan