Porter-Cable 33-412, 33-400, 33-422, 33-423), 33-421, 16 Starter BOX to Base, Table Boards and Fence

STARTER BOX TO BASE

1.Assemble bracket (A) to the bottom of the right side of saw base, (Fig. 12), using the 1/4-20x1/2" hex head screw (B), 1/4" lockwasher (D), and 1/4-20 nut (E).

2.Assemble the starter box (B) Fig. 13 to the right side of the base by inserting the three1/4-20x1/2" hex head screws (C) with 1/4" lock-washers, through the two holes in the base and the hole in the bracket and into the three 1/4-20 weld nuts in the back of the starter box. A cable clamp is supplied to attach the power cord to saw frame.

3.Fig. 14 illustrates the starter box assembled to the base.

D

E B

Fig. 12

Fig. 13 Fig. 14

TABLE BOARDS AND FENCE

1.Assemble loose table boards and fence (A) Fig. 15, on the table brackets.

2.Assemble three angle supports (B) Fig. 15 to the fixed front table board (C) using nine 1/4-20x7/8" round head screws and 9/32" flat washers (D).

Fig. 15 Fig. 16

3.Fig. 16 illustrates three angle supports (B) assembled to the fixed table board (C).

4.Place the smaller angled table board (D) Fig. 16, on the angle supports (B) and fasten with six 1/4- 20x7/8" round head screws and 9/32" flat washers shown at locations (E) Fig. 17.

Fig. 17

10