Porter-Cable 16, 33-400 Operation, Starting and Stopping SAW, Locking Switch in OFF Position

Page 13

4.Attach eyelet (H) Fig. 30 of cable assembly (C) to "S" bracket (E).

5.NOTE: To prevent premature wear of return reel cable, position the return reel so that the cable does not rub against the wall of the return reel.

E

C

H

Fig. 30

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING SAW

1.The on/off switch (A) Fig. 30A is located on the front of the saw. To turn the machine on, push the “START” button.

2.To turn the machine “OFF”, push the “STOP” button.

MAKE SURE THAT THE SWITCH IS IN

THE “OFF” POSITION BEFORE WIRING THE MACHINE. IN THE EVENT OF A POWER FAILURE, PUSH THE STOP BUTTON. AN ACCIDENTAL START- UP CAN CAUSE INJURY.

LOCKING SWITCH IN “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use, using a padlock (B) Fig. 30B with a 3/16" diameter shackle.

A

Fig. 30A

B

Fig. 30B

Every Delta Radial Arm Saw is thoroughly tested, inspected and accurately aligned before leaving the factory and, when delivered, is ready for operation after it is assembled. However, regardless of the care with which this or any piece of fine machinery is manufactured, inspected and shipped, it is possible that rough handling in shipment, or wear over a period of time may make minor adjustments necessary.

ALWAYS DISCONNECT MACHINE FROM POWER SOURCE BEFORE MAKING ANY ADJUST- MENTS.

13

Image 13
Contents 14, 16, and 18 Long Arm Radial Saws Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsManual Before Operating the Machine General Safety RulesAdditional Specific Safety Rules Functional Description Carton ContentsGuide to Parts Unpacking and CleaningAssembly Cuttinghead and CROSS-CUT Stop to TRACK-ARM Table Boards and Fence Starter BOX to BaseBlade Guard and Anti Kickback Device Adjusting Table TOP Parallel to TRACK-ARMCutterhead Return Spring Operation Locking Switch in OFF PositionStarting and Stopping SAW Taking Side Motion OUT of OVER-ARM Adjusting Ball Bearings Against Track RodsTightening Yoke Against Bearing Carriage Adjusting Track Rods Adjusting Bevel Clamp Handle Adjusting Blade Square with Table TOPAdjusting TRACK-ARM Clamp Handle Adjusting SAW Travel Square with Fence Removing Heeling in SAW CUT Adjustable CROSS-CUT StopChecking and Adjusting Automatic Brake Adjusting Blade GuardUsing a Table Extension Adjusting Tension on Cuttinghead Return AssemblyWrench Storage Brackets Auxiliary Table Board FacingCROSS-CUT Stop CROSS-CUTTINGMiter Cutting Ripping Compound Miter CuttingOUT-RIPPING IN-RIPPINGConstructing a Push Stick PushstickService Troubleshooting Guide MaintenanceWarranty AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers