Porter-Cable 33-413, 33-400, 33-422, 33-423), 33-421, 33-411, 16 Pushstick, Constructing a Push Stick

Page 23

CONSTRUCTING A PUSH STICK

When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made from scrap material by following the pattern shown in Fig. 58.

PUSHSTICK

Makefrom1/2″ OR3/4″WOOD orthicknesslessthan widthofmaterialtobecut.

Notchto

helpprevent

handfromslipping

Cutheretopush 1/4″ wood.

Cutheretopush 1/2″ wood.

1/2″ Squares

Fig. 58

23

Image 23

Contents 14, 16, and 18 Long Arm Radial Saws Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsManual Before Operating the Machine General Safety RulesAdditional Specific Safety Rules Functional Description Carton ContentsGuide to Parts Unpacking and CleaningAssembly Cuttinghead and CROSS-CUT Stop to TRACK-ARM Table Boards and Fence Starter BOX to BaseBlade Guard and Anti Kickback Device Adjusting Table TOP Parallel to TRACK-ARMCutterhead Return Spring Starting and Stopping SAW Locking Switch in OFF PositionOperation Tightening Yoke Against Bearing Carriage Adjusting Ball Bearings Against Track RodsTaking Side Motion OUT of OVER-ARM Adjusting Track Rods Adjusting TRACK-ARM Clamp Handle Adjusting Blade Square with Table TOPAdjusting Bevel Clamp Handle Adjusting SAW Travel Square with Fence Removing Heeling in SAW CUT Adjustable CROSS-CUT StopChecking and Adjusting Automatic Brake Adjusting Blade GuardAuxiliary Table Board Facing Adjusting Tension on Cuttinghead Return AssemblyUsing a Table Extension Wrench Storage BracketsMiter Cutting CROSS-CUTTINGCROSS-CUT Stop IN-RIPPING Compound Miter CuttingRipping OUT-RIPPINGConstructing a Push Stick PushstickService Troubleshooting Guide MaintenanceWarranty AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers