Multiquip SP-6457 TD operation manual Rules for Safe Operation, General Safety Warnings

Page 11

RULES FOR SAFE OPERATION

Most accidents involving product operation, maintenance and repair are caused by failure to observe basic safety rules and precautions. Accidents can often be avoided by recognizing potentially hazardous situations before an incident occurs.

General Safety Warnings

WARNING

§DO NOT operate or service this equipment before reading this entire manual. Failure to follow instructions may lead to serious injury or death.

§This equipment is to be operated by trained and qualified personnel only. This equipment should not be operated by persons under 18 years of age.

§This equipment is for industrial use and to be used for its intended purpose only.

§NEVER operate this equipment when not feeling well due to fatigue, illness or taking medicine.

§NEVER operate the saw under the influence of drugs or alcohol.

§NEVER use accessories or attachments, which are not recommended by Multiquip for this equipment. Damage to the equipment and/or injury to user may result. Manufacturer does not assume responsibility for any accident due to equipment modifications. Unauthorized equipment modification will void all warranties.

§NEVER operate this saw without proper protective clothing; shatterproof glasses, steel-toed boots, respiration mask, and any other protective devices required by the job.

11

Image 11

Contents SP-6457 TD Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard Rules for Safe Operation General Safety WarningsPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Model no SPEC. no Serial no Serial TagEngine Serial Before Starting OperationBlade Shaft Ratios Engine Power, Cutting Power & Sheave Size18612 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the BladeBlade Stacking Stacking Blades for Wide CutsInstalling the Blade Guard Installing and Removing the Blade GuardBlade Guard Water Supply Collar Guard, Installed Installing the Collar GuardWater Supply System Water Supply and ControlON-OFF Control PanelHandlebar Positions HandlebarsFueling the Saw UseRestarting After Running Out of Fuel Starting and Stopping The EngineDraining the Water System Cold Weather OperationGlow Plugs Block HeatersPointer Adjustment Pointer AdjustmentJoystick Handle Controls Raise Lower ControlsSetting the Depth Stop Setting the Depth IndicatorDrive System Controls Drive SystemTransaxle Transaxle4-Speed Blade Shaft Speed Blade ShaftGear Shift Components Shifting GearsTie-downs Night LightTransportation Tie-downs and Lift Point Lift Point Lift PointRemovable Guards and Access Panels MaintenanceBelt Tension Belts and PulleysEngine Mount Lock Bolts Adjusting Blade Shaft Drive Belt TensionReplacing the Jackshaft Belt Replacing the Blade Shaft BeltDo not OVER-TIGHTEN Rotary Belt TensionerBlade Shaft Replacement Blade Shaft MaintenanceRemoving the Inner Blade Collar Blade Collar Removal/InstallationInstalling the Inner Blade Collar Installing the Inner Blade CollarInner Collar Blade Shaft Circuit Breakers Maximum Cut Depth AdjustmentLubrication Engine Air and Oil Filter ChartAttaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive MaintenanceRe-Assembling the PTO Drive PTO Drive Sheave/Bearing AssemblyEngine Rotated Forward to Remove the Battery Replacing the BatteryRaise-Lower System Raise/Lower TroubleshootingJoystick Adjustment Joystick Tension AdjustmentRoutine Maintenance Hydraulic System MaintenanceTo drain the hydraulic system Draining & Filling the Hydraulic SystemTo fill the hydraulic system Bleeding the Depth Stop Cylinder Bleeding the Depth Stop CylinderDrive Wheel Alignment Drive Wheel AlignmentPivot Side Adjustment Side Specifications Dimensions Electric Diagram Www multiquip.com