4.If an air compressor is available, blow out the system by applying compressed air to the Water Inlet (see Fig. 10).
Pointer Adjustment
1.Lower the front pointer assembly.
∙Adjust the pointer rod (1) by loosening the lock knob (2).
∙Once the pointer rod is set to the cut line, tighten the lock knob.
2.Adjust the rear pointer to the cut line:
∙Loosen the lock bolt, position the pointer rod, and tighten the lock bolt.
3.To raise the front pointer assembly, pull back and up on the pointer cable (3).
∙Secure the pointer assembly in the desired raised position by locking the cable between the jaws of the cam cleat (5).
6 |
5 |
4 |
3 |
2 |
1 |
Fig. 15 — Pointer Adjustment
34