Multiquip TP7X operation manual Sawing guides, Using the Rip Guide, Performing Diagonal Cuts

Page 21

sawing guides

2.After the template base is positioned for the desired rip cut, place material flat against either side of the template base at the desired measurement.

Using the Rip Guide

1.Set the rip guide (Figure 12) at the desired location on the ruler guide and tighten the threaded knob. Make sure that the rip guide is firmly tightened to avoid slippage. The rip guide can be used for 45° and 90° cuts.

2.After the rip guide is positioned, for the desired cut, place material flat against the rip guide and ruler guide.

3.Now you are ready to make your cut.

Performing Diagonal Cuts

1.Place the corner of the material in the open slot of the measurement rail and adjust the template base to fit the correct tile size.

2.Line up the material being cut with the appropriate pre-marked lines on the cutting table.

3.Now you are ready to make your cut.

Performing Miter Cuts

Use the miter block to make miter cuts. See Figure 13.

1.Place the lip of the miter block on the ruler guide with the threaded knob facing you.

2.Position the miter block such that a tile laying flat against the block may rest its left-most edge within the vertical channel of the cutting table. Tighten the threaded knob to secure the miter block in place.

3.Place material onto miter block and you are ready to cut.

Figure 13. Miter Block

TP7X TILE SAW • operation manual — rev. #0 (03/04/11) — page 21

Image 21
Contents Model TP7X Proposition 65 Warning Silicosis Warning Silicosis/Respiratory WarningsTable of Contents Specifications are subject to change without noticeSawing Guides Page SaFeTy meSSageS Safety InformationGeneraL SaFeTy BLaDe SaFeTy SaW SaFeTyPower Cord/Cable Safety ELeCTrIC moTor SaFeTyLIFTIng SaFeTy TranSporTIng SaFeTyElectric Motor Specifications Saw SpecificationsDimension DimensionsFeatures Accessories/Replacement PartsGeneral information Dry Cutting ApplicationsPage Saw Components Saw componentsStopper Place stopper in water tray when filling with water Electric motor components/set-up Support Stand Assembly OptionalElectric Motor Components Saw Set-UpInstall drain plug in water tray Connecting the water PumpSet-up Refer to FigureBlade Components BladesCutting Depth Blade Diameter vs. Cutting DepthBlade Installation See for proper blade use guidelinesProper Blade Use Sawing Guides Using the Cutting Table Connecting the PowerUsing the MasterGuide Template Base Set-up/sawing guidesSawing guides Using the Rip GuidePerforming Diagonal Cuts Performing Miter CutsStart-up Procedure OperationStarting or attempting to operate the saw Wait for the cutting blade to stop rotating Shut down ProcedureInspect the cutting table periodically. Replace worn parts Basic MaintenanceAfter wet cleaning and before using the machine again Maintenance intervalsBefore not using the machine for a prolonged period of time After not using the machine for a prolonged period of timeWater pump maintenance Belt ReplacementBearing housing removal Bearing Housing Removal Bearing Housing InstallationElectric Motor Wiring Diagram Wiring diagram electric motorPage Blade Troubleshooting Troubleshooting bladeSaw Troubleshooting Troubleshooting SawHERE’S HOW to GET Help