set-up
Figure 5. Support Stand Assembly
connecting the water Pump
Refer to Figure 6.
1.Place the pump into the middle of the water tray along its side so that the water outlet is positioned horizontally.
2.Attach the water hose coming from the blade guard and bearing housing to the water pump.
3.Install drain plug in water tray.
4.Fill the water tray with clean fresh water. The water pump intake must always be fully covered by water. Also, keep the pump intake free of sludge, debris and other materials that may accumulate in the tray.
5.Make certain that the water hose will not come in contact with the blade or interfere with any moving parts.
6.Insert the water pump power plug into the outlet receptacle on the electric motor conduit box as shown in Figure 7.
ELECTRIC MOTOR
CONDUIT BOX
POWER
PLUG
ELECTRIC WATER
PUMP AC
RECEPTACLE
WATER
PUMP
Figure 7. Water Pump Power Connection
WARNING
Disconnect the pump before attempting to handle the pump. NEVER operate pump without water in the tray.
NOTICE
The above procedure is for wet cutting applications only. NEVER dry cut with the pump connected to an AC power source. Running the pump dry will damage the pump. ALWAYSdisconnectthepump’spowercordwhendrycutting.
WATER
PUMP
WATER
HOSES
DRAIN
PLUG
BLADE
GUARD
BEARING
HOUSING
Figure 6. Connecting the Water Pump
TP7X TILE SAW • operation manual — rev. #0 (03/04/11) — page 17